-
The database is configured in ARCHIVELOG mode and regular complete database backups are taken. Theloss of which two types of files may require a recovery with the RESETLOGS option? ()(Choose two)
A . Control files
B . Password files
C . Inactive online redo log file
D . Archived log files required to perform recovery
E . Newly created tablespace which is not backed u
-
Company.com is adding a new I/O drawer to an existing p5-570 with four LPARs and wants to re-balance the network cards in the I/O drawers. What is the best way to accomplish this?()
A . Add the devices as virtual adapters to a VIO server first,then add the I/O drawer and create the shared ethernet adapters
B . Power down the partitions,run the diag a command when the system is brought back up and reconfigure the network cards
C . Use the rmdev command to remove the devices,shut down the partitions and move the cads,then run the cfgmgr command after reboot
D . Detach the network cards,run rmdev on the devices and then dynamically reassign theadapters to the partitions and reconfigure
-
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()
A . the IP address of the first Fast Ethernet interface
B . the IP address of the console management interface
C . the highest IP address among its active interfaces
D . the lowest IP address among its active interfaces
E . the priority value until a loopback interface is configured
-
You have an Exchange Server 2010 organization with mailbox server in a lab environment.The lab is not connected to internet.You need to verify autodiscover is configured correctly for client connectivity.What will you use?()
A . Best practice analyzer
B . Remote connectivity analyzer
C . Test-MAPIconnectivity cmdlet
D . Test-outlookWeb services cmdlet
-
Which three protocols or applications should be placed in a class that is configured with WRED?()
A . HTTP
B . RTP
C . streaming video
D . BitTorrent
E . POP3
-
A new Aironet 1200 series AP has been installed in the Company WLAN. What happens when this device is connected to the LAN, with a default configuration?()
A . The access point will attempt to download an encryption key from the nearest wireless server.
B . The access point makes several attempts to get an IP address from the DHCP server. If the access point does not receive an address, it assigns itself the IP address 10.0.0.1 for 5 minutes.
C . The access point will attempt to connect to the nearest wireless server using LEAP authentication.
D . The access point requests an IP address from the DHCP server. If the access point does not receive an address, it continues to send requests indefinitely.
E . None of the other alternatives apply
-
You need to configure ISA3 in Seattle to enable communication with the network in New York.What should you do?()
A . Open the ports for DNS, HTTP, HTTPS, Kerberos, RADIUS, LDAP, RPC endpoint mapper and client, and Server Message Block (SMB) over IP
B . Enable the Routing and Remote Access Basic Firewall. Open the ports for DNS, Kerberos, LDAP, Exchange RPCs, RADIUS, L2TP, and Internet Key Exchange (IKE)
C . Create a PPTP tunnel from ISA3 to the New York network
D . Create an L2TP/IPSec tunnel from ISA3 to the New York network
-
Which two settings must be configured in order to use the GUI to configure Call Admission Control with voice applications?()
A . QoS must be set to Platinum
B . WMM must be enabled
C . QoS must be set to Gold
D . TSPEC must be disabled
E . Cisco Compatible Extensions must be disabled
-
In order to allow the establishment of a Telnet session with a router, which set of commands must be configured?()https://assets.asklib.com/images/image2/201807231503035435.jpg
A . A
B . B
C . C
D . D
E . E
F . F
-
The database is configured in ARCHIVELOG mode and regular complete database backups are taken. The loss of which two types of files may require a recovery with the RESETLOGS option?()
A . Control files
B . Password files
C . Inactive online redo log file
D . Archived log files required to perform recovery
E . Newly created tablespace which is not backed u
-
f a Cisco switch is configured with VTPv1 in transparent mode, what is done with received VTP advertisements?()
A . They are discarded
B . The contents are altered to reflect the switch’s own VTP database and then they are forward out all trunking ports
C . The changes within the advertisements are made to the switch’s VTP database.
D . The contents are ignored and they are forwarded out all trunking ports.
-
Which command would correctly configure a serial port on a router with the last usable host address in the 192.216.32.32/29 subnet?()
A . Router(config-if)# ip address 192.216.32.38 255.255.255.240
B . Router(config-if)# ip address 192.216.32.39 255.255.255.224
C . Router(config-if)# ip address 192.216.32.63 255.255.255.248
D . Router(config-if)# ip address 192.216.32.39 255.255.255.248
E . Router(config-if)# ip address 192.216.32.38 255.255.255.248
-
A solution provider has identified a number of risks with a configuration in a customer’s request for bid. What is the most appropriate action to take to mitigate those risks for the customer?()
A . Decide not to bid.
B . Provide a solution in the bid.
C . Provide a disclaimer in the bid.
D . Discuss options with the customer.
-
Refer to the exhibit. OSPF is configured on all routers in the network. On the basis of the show ip ospf n eighbor output, what prevents R1 from establishing a full adjacency with R2? ()https://assets.asklib.com/images/image2/2018073015404016990.jpg
A . Router R1 will only establish full adjacency with the DR and BDR on broadcast multi- access networks.
B . Router R2 has been elected as a DR for the broadcast multiaccess network in OSPF area 1.
C . Routers R1 and R2 are configured as stub routers for OSPF area 1 and OSPF area 2.
D . Router R1 and R2 are configured for a virtual link between OSPF area 1 and OSPF area 2.
E . The Hello parameters on routers R1 and R2 do not m atch.
-
In order to allow the establishment of a Telnet session with a router, which set of commands must be configured()。https://assets.asklib.com/images/image2/2018072310404858564.jpg
A . A
B . B
C . C
D . D
E . E
F . F
-
A customer with two x445 servers wants to have two NetXtreme Dual Port Gigabit Ethernet adapters installed in each server. What is the minimally supported configuration that will allow maximum throughput?()
A . Install the two cards in slots 5 and 6 in the x445.
B . Install the two cards in slots 3 and 5 in the x445 make sure slots 4 and 6 are not occupied.
C . Install an RXE-100 on each x445 and install one card in the x445 and one card in an RXE-100 on each system.
D . Connect an RXE-100 between the two x445s and install one card in each x445 and one card in each side of the RXE-100.
-
The routers named Testking1 and Testking2 are both configured with RIP only.What will happen in the event of Testking1 receiving a routing update that contains a higher cost path to a network already in its routing table?()
A . The update information will be added to the existing routing table.
B . The update information will replace the existing routing table entry.
C . The update will be ignored and thus no further action will occur.
D . The existing routing table entry will be purged from the routing table and all routers will attempt convergence.
-
You’re in a restaurant and a thin soup is served in a cup with no handles. To eat it you should: (单选5 分) (5.0分)
-
You’re at a table in a restaurant for a business dinner. Midway through the meal, you’re called to the telephone. What do you do with your napkin?
-
S0/0 on R1 is configured as a multipoint interface to communicate with R2 and R3 in the hub-and-spoke Frame Relay topology shown in the exhibit. Originally, static routes were configured between these routers to successfully route traffic between the attached networks. What will need to be done in order to use RIPv2 in place of the static routes?()
<img src='https://img2.soutiyun.com/shangxueba/ask/64407001-64410000/64409000/17b75ef15006e963a847746eb8ec9a38.png' />
A.Configure the no ip subnet-zero command on R1, R2, and R3.
B.Dynamic routing protocols such as RIPv2 cannot be used across Frame Relay networks.
C.Configure the S0/0 interface on R1 as two subinterfaces and configure point-to-point links to R2 and R3.
D.Change the 172.16.2.0/25 and 172.16.2.128/25 subnetworks so that at least two bits are borrowed from the last octet.
E.Change the network address configuration to eliminate the discontiguous 172.16.2.0/25 and 172.16.2.128/25 subnetwork.
-
You‘re working at TestKing as a network administrator when your MCSE assistant calls you for help. He has attempted to configure Router TK1 and incorrectly configured the router interface with a subnet broadcast address. You have to correct this by first removing the incorrect IP address and then re-entering the first usable IP address of the same subnet.How will you do this?()
A.<img src='https://img2.soutiyun.com/ask/uploadfile/2019-02-05/62f12c4fe6c949d9f231dc0439049925.jpg' />
B.<img src='https://img2.soutiyun.com/ask/uploadfile/2019-02-05/e1c96cd75eac41f2d1da5c29a3ba2682.jpg' />
C.<img src='https://img2.soutiyun.com/ask/uploadfile/2019-02-05/1a6856661df463ca52aec1f22d13ef33.jpg' />
D.<img src='https://img2.soutiyun.com/ask/uploadfile/2019-02-05/c3a2302bbd28c07bdbeb20fe35a870f6.jpg' />
E.<img src='https://img2.soutiyun.com/ask/uploadfile/2019-02-05/b4fe563461197276a690b4ebecf3a95f.jpg' />
-
What does the sentence "Today we're working with individual customers." in the third paragraph mean?
A.It means the company employs customers as its employees.
B.It means the company makes a product and looks for one customer to test it.
C.It means the company develops a product after doing research.
D.It means the company knows more about what customers want by providing additional services.
-
I'm in Paris, and a strangely quiet Paris it is. Nothing is going nowhere. If they're not on strike here, they're stuck in a traffic jam. It took me two hours to go two miles yesterday evening. And this morning many of the taxis, too, have joined in, leaving me with no alternative but to start walking. And it' s bitterly cold!
The strikes are serious protests about serious issues, but I'm struck, as so often on these occasions, by something much more mundane. People are once again talking to people; strangers are going out of their way to befriend strangers, allies for a week or two in their shared frustration. Parisian motorists, even, normally the most competitive of individualists, have been seen leaving notes in their parked cars saying where they are going and when they expect to leave in case anymore wants a lift.
Remove the technology of modem life, it seems, and we often start to be nice to one another again. Technology can isolate us, for all its benefits. It started, I guess, with the chimney. Before there were chimneys, we all had to huddle together in one room Just to keep warm, master and maid, cowman and son of the house. Then some unknown genius came up with the idea of the chimney, and the social stratification of society increased dramatically as all withdrew into their own quarters. Central heating, which is, more truthfully, decentralized heating, made it worse, and now we have our walkmans, our microwaves, or, if we' re really trendy, the Internet and e-mail. You can get by, these days, without actually speaking to anyone at all. Just the odd grunt to show that you' re alive !
I liked the survey which asked teenagers how they laid a table for a meal. Did they put the knife on the fight and the fork on the left, or did they put them both together? And 40 percent said one and 20 percent the other, but 40 percent didn't know! They had never sat down at a table together but had always, as they say, been grazers, helping themselves from the fridge and carrying the food off to their own comer to munch on their own.
If progress means that we don' t need to talk to each other anymore, then I'm getting worried. You can' t begin to love and befriend your neighbors if you never talk to them, and vice versa, they can't love you. It becomes a recipe for a world of solitaries. But most of us weren't destined to be hermits. People need people to be truly people, as the Parisians, in spite of all their frustrations, are discovering again this week. "Try walking instead" was my motto for this morning, but perhaps the motto for us all this festive month might be "Turn it off, whatever it is, and try talking instead!"
According to the author, the advent of modem technology may NOT______.
A.isolate us from the test of the society.
B.enable us to enjoy a much more convenient life.
C.leave people alone so that they may become truly people.
D.help people become grazers who are used to helping themselves from the fridge and carrying the food off to their own comer to munch on their own.
-
People now can know what' s happening in the world quickly.--You're right. With
A.A.get
B.B.arrive
C.C.return
D.D.reach