-
Which two of these are characteristics of Metro Ethernet?()
A . class of service
B . bandwidth profiles
C . user-network interface
D . Ethernet LAN circuit attributes
E . Ethernet virtual circuit attribute
-
Which two of these are characteristics of the 802.1Q protocol?()
A . it is a layer 2 messaging protocol which maintains vlan configurations across network.
B . it includes an 8-bit field which specifies the priority of a frame.
C . it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D . it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E . it is a trunking protocol capable of carring untagged frames.
-
Which of these statements concerning the collection interfaces are true?()
A . Set extends Collection.
B . All methods defined in Set are also defined in Collection.
C . List extends Collection.
D . All methods defined in List are also defined in Collection.
E . Map extends Collection.
-
Which two of these are recommended practices with trunks? ()
A . use ISL encapsulation
B . use 802.1q encapsulation
C . set ISL to desirable and auto with encapsulation negotiate to support ILS protocol negotiation
D . use VTP server mode to support dynamic propagation of VLAN information across the network
E . set DTP to desirable and desirable with encapsulation negotiate to support DTP protocol negotiation.
-
Which three of these statements about PPPoE are true?()
A . PPPoE can provide a host with access to a destination over Ethernet. You can have only one PPPoE session per PVC
B . You must install PPPoE client software on all hosts that connect to the Ethernet segment. This means that the access provider must maintain a CPE
C . You cannot use PPPoE with Cisco Service Selection Gateway
D . PPPoE implementation is susceptible to broadcast storms and possible denial-of-service attacks
E . Per-session accounting is possible, which allows the service provider to charge the subscriber based on session time for various services offered. The service provider can also require a minimum access charge
-
Which four of these are MPLS label header fields? ()
A . Label
B . VPI VCI
C . EXP
D . TTL
E . FCS
F . S flag
-
Which three of these are characteristics of UTP cable?()
A . The wires in each pair are wrapped around each other
B . An insulating material covers each of the individual copper wires in it
C . It comes in eight-pair wire bindles
D . EMI and RFI cause only limited degradation to signals running over it
E . It comes in seven categories
F . IT has an external diameter of approximately 0 28 inche
-
Which two of these are characteristics of MPLS VPNs? ()
A . Layer 3 MPLS VPNs can forward only IP packets
B . Layer 2 MPLS VPNs can forward any network protocol
C . MPL S label paths are automatically formed based on Layer 2 frames
D . Layer 3 MPLS VPNs can forward any network protocol based on Layer 2 frames
E . In Layer 2 MPLS VPNS, the service provider controls the customer Layer 3 policie
-
Which two of these statements are true of IPv6 address representation?()
A . There are four types of IPv6 addresses: unicast, multicast, anycast, and broadcast.
B . A single interface may be assigned multiple IPv6 addresses of any type.
C . Every IPv6 interface contains at least one loopback address.
D . The first 64 bits represent the dynamically created interface ID.
E . Leading zeros in an IPv6 16 bit hexadecimal field are mandatory.
-
Which three of these are benefits of telepresence and video collaboration?()
A . reduce the need to personalize communications with customers
B . do more with less
C . eliminate miscommunication
D . influence competitive advantage and business agility through faster decision-making and new business processes and models
E . transform your business and organization and be greener
F . provide a unified tool for all business processe
-
Which three of these are major components of an MPLS VPN network? ()
A . LDP notification
B . L2TPv3 session
C . VPN route target communities
D . Multiprotocol BGP peering of PE routers
E . MPLS forwarding
-
Which two of these are characteristics of an IDS sensor?()
A . passively listens to network traffic
B . is an active device in the traffic path
C . has a permissive interface that is used to monitor networks
D . traffic arrives on one IDS interface and exits on another
E . has a promiscuous interface that is used to monitor the network
-
Which two of these statements regarding RSTP are correct?()
A . RSTP cannot operate with PVST+.
B . RSTP defines new port roles.
C . RSTP defines no new port states.
D . RSTP is a proprietary implementation of IEEE 802.1D STP.
E . RSTP is compatible with the original IEEE 802.1D STP.
-
Which two of these are recommended practices with trunks? ()
A . use ISL encapsulation
B . use 802.1q encapsulation
C . set ISL to desirable and auto with encapsulation negotiate to support ILS protocol negotiation
D . use VTP server mode to support dynamic propagation of VLAN information across the network
E . set DTP to desirable and desirable with encapsulation negotiate to support DTP protocol negotiation.
-
Which two of these are recommended practices with trunks?()
A . use ISL encapsulation
B . use 802.1q encapsulation
C . set ISL to desirable and auto with encapsulation negotiate to support ILS protocol negotiation
D . use VTP server mode to support dynamic propagation of VLAN information across the network
E . set DTP to desirable and desirable with encapsulation negotiate to support DTP protocol negotiatio
-
Which two of these are characteristics of Metro Ethernet? ()
A . class of service
B . bandwidth profiles
C . user-network interface
D . Ethernet LAN circuit attributes
E . Ethernet virtual circuit attribute
-
You are creating tablespaces in Oracle. Which of the following keywords or clauses permits the datafiles of a database to grow automatically in order to accommodate data growth?()
A . DEFAULT STORAGE
B . EXTENT MANAGEMENT
C . AUTOEXTEND
D . DATAFILE
-
Which two of these are characteristics of an IPS device?()
A . passively listens to network traffic
B . is an active device in the traffic path
C . has a permissive interface that is used to monitor networks
D . traffic arrives on one IPS interface and exits on another
-
Which two of these are characteristics of multicast routing? ()
A . multicast routing uses RPF
B . multicast routing is connectionless.
C . In multicast routing, the source of a packet is known.
D . When network topologies change, multicast distribution trees are not rebuilt, but use the originalpath
E . Multicast routing is much like unicast routing, with the only difference being that it has a a groupof receivers rather than just one destinatio
-
Which two of these statements regarding RSTP are correct?()
A . RSTP cannot operate with PVST+.
B . RSTP defines new port roles.
C . RSTP defines no new port states.
D . RSTP is a proprietary implementation of IEEE 802.1D STP.
E . RSTP is compatible with the original IEEE 802.1D STP.
-
Which two of these are characteristics of an IPS device?()
A . passively listens to network traffic
B . is an active device in the traffic path
C . has a permissive interface that is used to monitor networks
D . traffic arrives on one IPS interface and exits on another
-
Which two of these are characteristics of the 802.1Q protocol?()
A . it is a layer 2 messaging protocol which maintains vlan configurations across network.
B . it includes an 8-bit field which specifies the priority of a frame.
C . it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D . it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E . it is a trunking protocol capable of carring untagged frames.
-
Which of these statements are NOT part of a Personal Enterprise Plan?
-
Which are not the keywords of Python()
A.as
B.dict
C.list
D.is