When surveying for VoWLAN, which power level should you base the access point coverage designon?()
Refer to the exhibit. Which three options are available when the Cisco Wireless Control System (WCS) discovers rogue access points on the LAN?()https://assets.asklib.com/images/image2/2018072416180978608.jpg
You are the Cisco Network Designer in Cisco.com. Your company is using the G.711 codec with 802.11a access point radios. This can support a maximum of how many phones per access point?()
A Cisco Aironet 1020 controller-based access point has been connected to a Catalyst 3550-24 PWRSwitch. However, when it is powered up, the access point fails. What has caused this problem?()
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it, allthe LEDs on the access point blink together. What does this indicate about the access point?()
You are the Cisco Network Designer in Cisco.com. Which signal and noise values will result in thebest phone communication with an access point?()
You are the Cisco Network Designer in Cisco.com. Which signal and noise values will result in the best phone communication with an access point?()
You are the Cisco Network Designer in Cisco.com. Which of these are important when determining how many users a NAS can support?()
You are the network consultant from Cisco.com. Please point out which Layer 2 access designs does not support VLAN extensions?()
You are the Cisco Network Designer in Cisco.com. Which two statements about Layer 3 access designs are correct?()
When using Cisco Network Assistant to configure smartports, Which tow of the following roles can belong to a VLAN of the type "access" ?()
In CRS Administration, when you add a JTAPI Call Control Group, what is created on the Cisco CallManager?()
You are installing a cisco aironet 1000 series controller-based access point. when you boot it, all the leds on the access point blink together. What does this indicate about the access point?()
When using the Cisco SDM Quick Setup Siteto-Site VPN wizard, which three parameters do you configure?()
What is the maximum recommended height at which a cisco aironet 1000 series controller-based access point should be mounted when using integrated antennas?()
A Cisco Aironet 1020 controller-based access point has been connected to a Catalyst 3550-24PWR Switch. However, when it is powered up, the access point fails. What has caused this problem?()
A cisco aironet 1020 controller-based access point has been connected to a catalyst 3550-24 pwr switch. however, when it is powered up, the access point fails. What has caused this problem?()
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it, allthe LEDs on the access point blink together. What does this indicate about the access point?()
You are the network consultant from Cisco.com. Please point out the reason that STP required when VLANs do not span access layer switches.()
What s the default stratum clock on a Cisco router,when you see the key word "master" configured on the NTP line?()
As a Pass Guide instructor you are giving a lecture on the historical context of Cisco. You point out that a computer scientist started the Cisco Corporation. One of the attendants asks you when and where Cisco was founded. What should you respond? ()
When you enter the interface command auto qos voip cisco-phone on a port at the edge of a network,how does the Cisco Catalyst switch detect if a Cisco IP Phone is connected to the port?()
As a TestKing instructor you are giving a lecture on the historical context of Cisco. You point out that a computer scientist started the Cisco Corporation. One of the attendants asks you when and where Cisco was founded. What should you respond? ()