-
Which of the items listed causes a direct acting mechanical governor to operate the engine fuel control linkage?（）
A . Hydraulic oil pressure
B . Servomotor action
C . Flyweight centrifugal force
D . Relay motio
-
UMS are mainly unattended overnight and during this time （） should have control of the main engine.
A . the chief engineer
B . the engineer on cabin watch
C . the bridge officer on watch
D . the master
-
Under which of the listed conditions can the engine room retake the throttle control from the bridge（）.
A . Any time it is deemed necessary
B . Only with the masters permission
C . After a 10 minute delay to the input command
D . Only after the throttle has been placed in sto
-
A Cisco Application Control Engine Appliance （ACE） non-admin context does not support "sticky" configuration. What is the reason for this issue？（）
A . ACE sticky license is not installed
B . ACE stickiness is not supported in a non-admin context
C . ACE stickiness resources are not defined in an admin context
D . Stickiness is configured properly in the CCIE virtual context
-
You create a multiple form application- Which built-in must you use to invoke the form modules to enable you to programmatically control navigation between the multiple forms in your application?（）
A . NEW_FORM
B . OPEN_FORM
C . CALL_FORM
D . CLOSE_FORM
-
Which of these is true regarding the configuration and application of port access control lists？ （）
A . PACLs can be applied in the inbound or outbound direction of a Layer 2 physical interface.
B . At Layer 2， a MAC address PACL will take precedence over any existing Layer 3 PACL.
C . When you apply a port ACL to a trunk port， the ACL filters traffic on all VLANs present on the trunk port.
D . PACLs are not supported on EtherChannel interfaces.
-
You create a control named ContosoUI for a Web application. You need to add the control to the toolbox of Microsoft Visual Studio .NET. Which two actions should you perform?（）
A . Create the ContosoUI control as a Web Control Library.
B . Create the ContosoUI control as a Web user control.
C . Within the Visual Studio .NET toolbox, browse to and select ContosoUI.ascx.
D . Within the Visual Studio .NET toolbox, browse to and select ContosoUI.dll.
-
On a diesel engine equipped with an isochronous governor, if the “speed droop” control is reduced to the “zero” setting, the engine （）
A . speed will drop drastically with any increase in load
B . will stop due to zero fuel supply
C . will stall upon application of load
D . speed will remain fairly constant despite load change
-
ENGINE CONTROL灯亮意味着（）
A . 有故障，但有可能可以放行
B . 发动机停车
C . 有故障，且不能放行
-
You are developing a Asp.net web application tht includes a panel control that has ID contentsection.You need to add a textBox control to the panel control.（）
A . this.RequireControlState（this.LoadControl（typeof（TextBox），null））；
B . this.ContentSection.control.add（this.FindControl（ContentSection.ID + "asp：TextBox"））；
C . this.ContentSection.control.add（this.LoadControl（typeof（TextBox），null））；
D . this.LoadComplete（"asp：TextBox"）.IntiantiateIn（Content Section）
-
The additional mark （）in the Classification Certificate for Machinery means propulsion apparatus is remotely controlled on the navigating bridge control station, and engine assembly control station is watched by duty personnel.
A . BRC
B . MCC
C . AUT-0
D . AUT-1
-
Engine protection by means of an alarm or shutdown control can be obtained with devices that are sensitive to （）.
A . temperature
B . pressure
C . engine speed
D . all of the above
-
“ENGINE CONTROL”灯在以下那种条件时亮？（）
A . 飞机在地面，速度不超过80节
B . N2转速大于50%
C . 存在一个不可放行的故障
D . 以上条件应同时满足
-
What is the purpose of this command in a Cisco Application Control Engine？（） switch/Admin# show np 1 me-stats "-F0 v"
A . It displays the status of the internal SSL proxy structure associated with a vserver.
B . It displays the crypto-related statistics for a single NP.
C . It is the same output of a "show stats crypto" client/server.
D . It shows details on HTTP session entries.
-
With UMS, when the engine room is unwatched （） will control the main engine.
A . the bridge officer on watch
B . the chief engineer
C . the duty engineer
D . the duty motorma
-
The hydraulic （） is used to control engine speed.
A . motor
B . pump
C . governor
D . capsta
-
以下关于“ENGINE CONTROL”指示的说法错误的是（）.
A . 当“ENGINE CONTROL”灯亮时，飞机不能派遣放行
B . 只有当飞机在地面时，灯才会亮
C . 只要EEC发现一个非派遣性故障，灯就亮
D . N2转速必须大于50%，灯才会亮
-
You are creating a templated Web control for use in your Web application. You need to add the Web control to your Web application pages without compiling your control into a .dll file. What should you do?（）
A . Ensure that the Web control inherits from the WebControl class.
B . Ensure that the Web control inherits from the Control class.
C . Ensure that the Web control inherits from the CompositeControl class.
D . Ensure that the Web control inherits from the UserControl class.
-
Main diesel engine control can be obtained by the bridge （）
A . at any time
B . only after the engine room control station is switched to ‘bridge control’
C . whenever the secondary station is switched to ‘bridge control’
D . whenever the engine side control station is switched to ‘bridge control&rsquo
-
Which switching engine enables the access control list lookup to be committed to hardware? （）
A . IETF
B . PFC
C . ASIC
D . TCAM
-
You are creating a Windows Forms application by using the .Net Framework 3.5.You plan to design a composite control for the application.You need to derive the control from a base class that supports templates.What should you do？（）
A . Derive from the Control class.
B . Derive from the UserControl class.
C . Derive from the ScrollableControl class.
D . Derive from the ContainerControl class.
-
Fuel injection uses the jet pump system and a Woodward type hydraulic （） is used to control engine speed.
A . controller
B . governor
C . instrument
D . apparatu
-
You are creating a templated Web control for use in your Web application. You need to add the Web control to your Web application pages without compiling your control into a .dll file.What should you do？（）
A. Ensure that the Web control inherits from the WebControl class.
B. Ensure that the Web control inherits from the Control class.
C. Ensure that the Web control inherits from the CompositeControl class.
D. Ensure that the Web control inherits from the UserControl class.
-
You use Microsoft Visual Studio 2010 and Microsoft .NET Framework 4 to create a Windows Presentation Foundation (WPF) application.The application contains a ListBox control named lbxItems that is data-bound to a collection of objects. Each object has a DisplayValue property.You add a Button control to the application.You need to ensure that the Content property of the Button control is data-bound to the DisplayValue property of the selected item of lbxItems.Which binding expression should you use？（）
A.{ Binding ElementName=lbxItems, Source=SelectedItem, Path=DisplayValue }
B.{ Binding Source=lbxItems, ElementName=SelectedItem, Path=DisplayValue }
C.{ Binding ElementName=lbxItems, Path=SelectedItem.DisplayValue }
D.{ Binding Source=lbxItems, Path=SelectedItem.DisplayValue }
