In an oil cooler circulated by sea water, the oil is at a larger pressure the result being that any leak in the cooler will mean a loss of ().
A . oil
B . sea water
C . refrigerant
D . fresh water
相似题目
-
When used in conjunction with a turbocharger, the main function of an after-cooler is to ()
A . increase the density of the cylinder air charge
B . prevent turbocharger overheating
C . liminate the need for a pre-cooler
D . remove moisture from air compressed by the turbocharger
-
In a medium speed diesel engine, a trunk type piston may be cooled by() Ⅰ.oil circulation though passages in the piston crown Ⅱ.heat transfer through piston rings and liner wall
A . Ⅰ only
B . Ⅱ only
C . either Ⅰ or Ⅱ
D . neither Ⅰ or Ⅱ
-
An oil water monitor is required in order to measure ().
A . the oil content in water
B . the water content in fuel oil
C . the water level in bilge well
D . the oil level in bilge well
-
In an oily water separator the oil will travel () to the oil collecting spaces.
A . upwards
B . downwards
C . outwards
D . forward
-
When oil is discharged overboard,an entry is required in the().
A . engine rough log
B . Oil Record Book
C . Official Logbook
D . deck rough log
-
In a central cooling system, used in some modem ships, sea water is supplied to cool ()which will circulate to other individual cooler, greatly reducing the corrosion problems.
A . fresh water
B . sea water
C . cooling oil
D . emulsio
-
An oil in water monitor is required in order to measure ().
A . the oil content in water
B . the water content in fuel oil
C . the water level in bilge well
D . the oil level in bilge well
-
Fuel oil contamination of an auxiliary diesel engine lube oil can result in()
A . an increased flash point
B . higher lube oil pressures
C . an increased viscosity
D . lower lube oil pressure
-
In cleaning up an oil spill, the use of chemical agents would ().
A . absorb the oil for easy removal
B . remove the oil from the water
C . disperse or dissolve the oil in the water
D . not affect the oil
-
Improper maintenance of the fuel oil burners in an automatically fired auxiliary boiler, could result in ()
A . increased fuel consumption
B . increased feed water consumption
C . fuel pump failure
D . combustion control system failure
-
In a general oil cooler circulated by sea water, the oil is at a higher pressure, the result being that any leak in the cooler will mean a loss of ().
A . oil
B . sea water
C . air
D . fresh water
-
With respect to the flow of lubricating oil through a diesel engine, the lube oil coolers are located after filters in order to ().
A . allow filtration of less viscous oil
B . decrease the pressure drop across the filter
C . improve overall filtration
D . all of the above
-
An important consideration in selecting a lubricating oil for use in a refrigeration compressor is for the oil to ()
A . have a high viscosity index
B . mix readily with refrigerant
C . have a high freezing point
D . have a low pour point
-
In the Northern Hemisphere,an area of counterclockwise wind circulation surrounded by higher pressure is a().
A . low
B . high
C . warm front
D . cold front
-
The temperature difference between the inlet and outlet temperature of the lube oil cooler in the lubricating system for the diesel engine is generally between ().
A . 8-10℃
B . 10-12℃
C . 10-15℃
D . 10-20℃
-
() is the breakdown of surface tension between oil droplets in an oil water mixture which causes them to join and increase in size.
A . Wear
B . Contaminating
C . Coalescence
D . Coarse separating
-
In which of the listed hydraulic systems will the installation of an oil cooler be necessary?()
A . Constant tension mooring winch system
B . Hatch cover system
C . Watertight door system
D . Internal combustion engine hydraulic starter system
-
(EMB145)FCOC(Fuel Cooled Oil Cooler)装在()
A . FDMU的下游
B . FDMU的上游
C . 在FPMU的齿轮泵和离心泵之间
-
Lubricating oil viscosity in an operating diesel engine can be reduced by()
A . increasing cooling water flow
B . increasing lube oil flow
C . dilution by fuel oil
D . adding SAE 70 oil
-
Improper maintenance of an automatic auxiliary boiler oil burner could result in ().
A . fuel pump failure
B . fan motor failure
C . increased feedwater consumption
D . decreased boiler efficiency
-
Coalescence is the breakdown of surface tension between oil droplets in an oil/water mixture, which causes them to join and () in size.
A . expand
B . extract
C . increase
D . decrease
-
Fueling results in the collection of waste oil in drip pans and containers. Which is an approved method of disposing of the waste oil? ()
A . Draining it overboard when the vessel gets underway
B . Placing it in proper disposal facilities
C . Adding sinking agents and discharging it into the water
D . Mixing it with dispersants before draining it overboard
-
Excessive circulation of the lubricating oil with the refrigerant in a refrigeration system will cause______.
A.carbon deposits on the compressor suction valves
B.the evaporator temperature to increase
C.rapid corrosion of the thermal expansion valve
D.no operating problems