-
Which two can directly cause a thread to stop executing?()
A . Exiting from a synchronized block.
B . Calling the wait method on an object.
C . Calling the notify method on an object.
D . Calling the notifyAll method on an object.
E . Calling the setPriority method on a thread object.
-
Which two CANNOT directly cause a thread to stop executing? ()
A . Existing from a synchronized block.
B . Calling the wait method on an object.
C . Calling notify method on an object.
D . Calling read method on an InputStream object.
E . Calling the SetPriority method on a Thread object.
-
Which two can directly cause a thread to stop executing?()
A . Exiting from a synchronized block.
B . Calling the wait method on an object.
C . Calling the notify method on an object.
D . Calling the notifyAll method on an object.
E . Calling the setPriority method on a thread object.
-
In a lab, two routers are connected directly together using serial interfaces in a back-to-back configuration. No external DCE devices are being used. What additional command is needed to bring this link up?()
A . serialup
B . clock
C . clockrate
D . dcerate
E . dterate
-
Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?()
A . enable cdp
B . cdp enable
C . cdp run
D . run cd
-
You have two EBGP peers connected via two parallel serial lines. What should you do to be able to load-balance between two EBGP speakers over the parallel serial lines in both directions? ()
A . nothing,BGP automatically load-balances the traffic between different autonomous systems on all available links
B . peer between the eBGP speaker’s loopbacks, configuring eBGP multihop as required, and use an IGP to load-share between the two equal-cost paths between the loopback addresses
C . configure a loopback as update source for both EBGP peers and have on each AS an IGP to introduce two equal-cost paths to reach the EBGP peer loopback address;it is also necessary to use the next-hop-self command
D . use the ebgp-load-balance command on the neighbor statement on both sides
E . configure a loopback as update source for both EBGP peers and have on each AS an IGP to introduce two equal-cost paths to reach the peer loopback address;it is also necessary to use the ebgp-multihop and next-hop-self command
-
This arrangement is () if the elements are directly connected to one another and the control action takes place without human involvement.
A . a manual closed loop
B . a manual opened loop
C . an automatic closed loop
D . an automatic opened loo
-
Which of the following must match for two directly connected routers running OSPF to establish a neighbor adjacency?()
A . area IDs
B . process IDs
C . router IDs
D . hello timer
-
Which two are true regarding direct-path exports?()
A . Direct-path export is typically faster.
B . Direct-path export can be invoked interactively.
C . Direct-path export is character set independent.
D . Direct-path export bypasses the SQL-command processing layer.
E . Direct-path export can be used to export rows containing LOBs and BFILEs.
-
Which wireless LAN statistics are reported from the Cisco Unified Wireless IP Phone 7921G via a directly connected web browser?()
A . duplicate sender packets
B . unicast packet retry rate
C . unicast packet retry ratio
D . association rejectio
-
Vee-type engines have the connecting rods from two cylinders connected to each () of the crankshaft.
A . throw
B . web
C . main bearing
D . deflectio
-
Which two statements about Oracle Direct Network File System (NFS) are true?()
A . It bypasses the OS file system cache.
B . A separate NFS interface is required for use across Linux, UNIX, and Windows platforms.
C . It uses the operating system kernel NFS layer for user tasks and network communication modules.
D . File systems need not be mounted by the kernel NFS system when being served through Direct NFS.
E . Oracle Disk Manager can manage NFS on its own, without using the operating system kernel NFS driver.
-
What are two reasons for packet loss on a VoIP connection?()
A . serialization delay
B . overrun
C . full buffers and queues
D . propagation delay
E . shaping delay
F . TCP header error
-
Which two options are valid WAN connectivity methods?()
A . PPP
B . WAP
C . DSL
D . Ethernet
E . L2TPv3
-
Which two steps check out a database connection from the connection pool?()
A . DB Get
B . DB Read
C . DB Write
D . DB Release
-
Which two CANNOT directly cause a thread to stop executing?()
A . Calling the yield method.
B . Calling the wait method on an object.
C . Calling the notify method on an object.
D . Calling the notifyAll method on an object.
E . Calling the start method on another Thread object.
-
What is the correct fastpath to configure or add a TTY Terminal (directly from the screen), which connects to a serial port?()
A . smitty tty
B . smitty devices
C . smitty pty
D . smitty dev
-
Which two directives are applicable only to tag files?()
A . Tag
B . Page
C . Taglib
D . Include
E . Variable
-
Which DSL encapsulation method requires client software running on the end - user PC that is directly connected to a DSL modem?()
A . PPPoA
B . PPPoE
C . PPP
D . L2TP
E . ATM
-
Which two CANNOT directly cause a thread to stop executing?()
A . Calling the yield method.
B . Calling the wait method on an object.
C . Calling the notify method on an object.
D . Calling the notifyAll method on an object.
E . Calling the start method on another Thread object.
-
What was the direct connection between members of the speaker's family and Shakespeare?
A.They owned Shakespeare's birthplace.
B.They went to Shakespeare's old school.
C.They lived near Shakespeare's house.
D.They shared Shakespeare's first name.
-
45、请参见图示。R2 路由表如下: Gateway of last resort is not set 10.0.0.0/30 is subnetted, 2 subnets C 10.0.0.0 is directly connected, Serial0/0/0 C 10.0.0.4 is directly connected, Serial0/0/1 192.168.10.0/26 is subnetted, 3 subnets S 192.168.10.0 is directly connected, Serial0/0/0 C 192.168.10.64 is directly connected, FastEthernet0/0 S 192.168.10.128 [1/0] via 10.0.0.6 路由器R2用19216.81.129的数据包做什么?
A.丢弃数据包
B.将数据包发送到接口 Serial0/0/0
C.将数据包发送到接口 Serial0/0/1
D.将数据包发送到接口 FastEthernet0/0
-
The slow-speed desel engines can be connected directly to the propeller without ().
A.shafts
B.bearings
C.reduction gear box