-
Router A is unable to reach Router B.Both routers are running ios version 12.0.After reviewing the command output and graphic,what is the most likely cause of the problem?()
A . incorrect bandwidt h configuration
B . incorrect LMI configuration
C . incorrect map statement
D . incorrect IP addre
-
Which is true about OSPF router-id?()
A . It is used for type 1 router LSA
B . Highest IP address of the loopback is used
C . router-id needs to be matched on ospf neighbors
D . router-id is 16 bit
-
Which model of the Cisco 1800 Series Integrated Services Router is Modular?()
A . 1812
B . 1814
C . 1802
D . 1811
E . 1841
-
There is MPLS VPN traffic traversing through a TE intermediate router. What is the MPLS packet labelstack sequence (from outer to inner) for the VPN traffic on this router?()
A . TE label, IGP label, VPN label
B . IGP label, TE label, VPN label
C . TE label, VPN label, IGP label
D . VPN label, IGP label, TE label
E . IGP label, VPN label, TE label
-
In which solution is a router ACL used?()
A . protecting a server frome unauthorized acces
B . controlling path selection,based on the route metric
C . reducing router CPU utilization
D . filterring packets that are passing through a router
-
A new router is added to an existing HSRP standby group. One of the existing routers is in anactive state, the other is in a standby state. Under what circumstance will the new router becomethe active router?()
A . The new router will become active immediately because it’s the newest router introduced intothe group
B . The new router can become active only when the existing active router and the existing standbyrouter become unavailable
C . The new router has a lower priority value
D . The new router will never become active unless the existing active router becomes unavailable
E . The new router has preempt configured and a higher priority
F . The new router has a higher priority value
-
Which IS - IS router is equivalent to an ABR in OSPF?()
A . Level 2 - 3
B . Level 1 - 2
C . Level 2
D . Level 0
E . Level 3
F . Level 1
-
Which of the following statements is true about a router's eBGP peers that is not also true about that same router's iBGP peers?()
A . The eBGP peer neighborship uses TCP
B . The eBGP peer uses port 180 (default)
C . The eBGP peer uses the same ASN as the local router
D . The eBGP peer updates its AS_Path PA before sending updates to this router
-
Which router or router combination is used to calculate the MPLS traffic engineering tunnel path?()
A . head-end router and tail-end router
B . middle-point router
C . head-end router
D . tart-end router
E . tail-end router
-
What is a new feature of the Cisco ISR router? ()
A . advanced integration module
B . FICON ports
C . Cisco CallManager 5.0 support
D . warm Cisco IOS upgrade feature
-
In which solution is a router ACL used?()
A . protecting a server frome unauthorized acces
B . controlling path selection,based on the route metric
C . reducing router CPU utilization
D . filterring packets that are passing through a router
-
A router receives a packet on interface 172.16.45.66/26. The source IP of the packet is 172.16.45.127/26 and the destination is 172.16.46.191/26.How will the router handle the packet?()
A . The destination is a host on another subnet, so the router will not forward the packet.
B . The destination is a host on the same subnet, so the router will forward the packet.
C . The destination is a broadcast address, so the router will not forward the packet.
D . The destination is a network address, so the router will forward the packet.
-
Which of the following HSRP router states does an active router enter when it is preempted by a higher priority router?()
A . active
B . speak
C . learn
D . listen
E . init
F . standby
-
When is an IPSec SA built on the Teleworker Router?()
A . when the router is booted up
B . when the router administratively does a no shutdown" on the IPSec SA
C . when traffic matches a line of the access-list tied into the crypto-map in the router configuration, and that particular IPSec SA is not already up
D . when the ISAKMP SA completes negotiation of all IPSec SAs (one per access-list line in the crypto ACL), it will be brought up immediately
-
A cisco router is booting and has just completed the POST process.It is now ready to find and load an IOSimage.what function does the router perform next?()
A . It checks the configuration register
B . It attempts to boot from a TFTP server
C . It loads the first image file in flash memory
D . It inspects the configuration file in NVRAM for boot instructio
-
What is IPv6 router solicitation?()
A . a request made by a node to join a specified multicast group
B . a request made by a node for its IP address
C . a request made by a node for the IP address of the DHCP server
D . a request made by a node for the IP address of the local router
-
Which statement about the ip classless router command is true?()
A . The ip classless command is enabled by default in recent versions of IOS.
B . The ip classless command should only be enabled when static routing is being used instead of a routing protocol.
C . The ip classless command should be enabled by the network administrator whenever RIPv1 or IGRP is being used.
D . The ip classless command should be enabled by the network administrator whenever OSPF, RIPv2, or EIGRP is being used.
-
Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true?()
A . The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2
B . The configuration is invalid because the DHCP options are global configuration commands
C . The configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfaces
D . The router will choose which pool to use based upon the interface the DHCP request wasreceived o
-
A Cisco router is booting and has just completed the POST process. It is now ready to find and load an IOS image. What function does the router perform next?()
A . It checks the configuration register.
B . It attempts to boot from a TFTP server.
C . It loads the first image file in flash memory.
D . It inspects the configuration file in NVRAM for boot instructions.
-
A cisco router is booting and has just completed the POST process.It is now ready to find and load an IOS image.what function does the router perform next?()
A . It checks the configuration register
B . It attempts to boot from a TFTP server
C . It loads the first image file in flash memory
D . It inspects the configuration file in NVRAM for boot instructio
-
路由器使用Router-ID生成IS-IS进程NET地址的益处有()。
A.Router-ID和NET中的Stem-ID默认就是绑定的,便于维护
B.NET由Router-ID生成,便于记忆
C.使用全网唯一的Router-ID能够保证全网路由器IS-IS进程NET的唯一性
D.若发生设备替换,Router-ID和Stem-ID都可以灵活修改
-
There are three IS-IS routers on a Gigabit Ethernet segment: Router A, Router B, and Router C. Each router is configured in the same area and each routers Gigabit Ethernet interface is configured for Level 1-only. Router A is the Designated Intermediate System (DIS). Each routers IP address on that segment is:Router A: 10.1.1.1/24Router B: 10.1.1.2/24Router C: 10.2.2.1/26Which statement is true about all the adjacencies that exist on that LAN?()
A. No routers are adjacent with each other.
B. Only Router A and Router B are adjacent at Level 1.
C. Only Router A and Router B are adjacent at Level 2.
D. All three routers are adjacent with each other at Level 1.
-
You have a Level 1-only router (Router A) in IS-IS area 49.0001.How does Router A learn how to reach prefixes in other areas?()
A. Router A must have a Level 2 adjacency with the Level 1/Level 2 router in area 49.0001.
B. The Level 1/Level 2 router in area 49.0001 sets the "attached" bit in the Level 2 LSP it floods into area 49.0001.
C. The Level 1/Level 2 router in area 49.0001 sets the "attached" bit in the Level 1 link-state PDU (LSP) it floods into area 49.0001.
D. The Level 1/Level 2 router in area 49.0001 advertises these prefixes into area 49.0001 using a Level 2 LSP it floods into the area.
-
路由器使用Router-ID生成IS-IS进程NET地址的益处有()
A.NET由Router-ID生成,便于记忆
B.若发生设备替换,Router-ID和System-ID都可以灵活修改
C.Router-ID和NET中的System-ID默认就是绑定的,便于维护
D.使用全网唯一的Router-ID能够保证全网路由器1S-1S进程NET的唯一性