-
Which statement describes the call behavior of the Cisco Unified Wireless IP Phone 7921G when it roams from 802.11b to 802.11a?（）
A . The phone does a directed call hangup on 802.11b，then does an auto-redial on 802.11a，creating a new call.
B . The phone does a directed call hangup on 802.11b， then the user does a redial on 802.11a，creating a new call.
C . The phone does a disassociation on 802.11b and an association on 802.11a，and call remains up if the subnet has not changed.
D . The phone does not roam from 802.11b to 802.11a when on an active call.
E . The phone must switch network profiles to roam from 802.11b to 802.11a.
-
When configuring cisco secure acs to support wireless eap authentication，which device must be configured as a aaa client？（）
A . location appliance
B . controller-based access points
C . wireless clients
D . wireless control system
E . wireless controller
-
Which of these is mandatory when configuring Cisco IOS Firewall？ （）
A . Cisco IOS IPS enabled on the untrusted interface
B . NBAR enabled to perform protocol discovery and deep packet inspection
C . a route map to define the trusted outgoing traffic
D . a route map to define the application inspection rules
E . an inbound extended ACL applied to the untrusted interface
-
When implementing OSPFv3, which statement describes the configuration of OSPF areas?（）
A . In interface configuration mode, the OSPFv3 area ID combination assigns interfaces to OSPFv3 areas.
B . In router configuration mode, the network wildcard area ID combination assigns networks to OSPFv3 areas.
C . In interface configuration mode, the IPv6 OSPF process area ID combination assigns interfaces to OSPFv3 areas.
D . In router configuration mode, the IPv6 OSPF interface area ID combination assigns interfaces to OSPFv3 areas.
-
When configuring Frame Relay using point-to-point subinterfaces, which of the following must not be configured?（）
A . The local DLCI on each subinterface of the Frame Relay.
B . The Frame Relay encapsulation on the physical interface.
C . An IP address on the physical interface.
D . The subinterface type as point-to-point
-
What OSPF command, when configured, will include all interfaces into area 0?（）
A . network 0.0.0.0 255.255.255.255 area 0
B . network 0.0.0.0 0.0.0.0 area 0
C . network 255.255.255.255 0.0.0.0 area 0
D . network all-interfaces area 0
-
When configuring a wireless LAN controller for QoS， what 802.1p tag should be applied for video applications？ （）
A . 3
B . 1
C . 4
D . 6
-
Which Cisco CRS 4.0 server configuration task enables the Cisco CRS server to fail over to a secondary Cisco Unified CallManager when the primary Cisco Unified CallManager fails?（）
A . The LDAP directory must have a secondary profile configured.
B . No special configuration is required. Cisco Unified CallManager maintains the failover.
C . The JTAPI provider on the Cisco CRS server must be configured with the secondary Cisco Unified CallManager IP address following the primary Cisco Unified CallManager IP address.
D . There must be a second JTAPI user configured with an alternate range of CTI ports.
-
What interface is created when an FC Port Channel is created on a Cisco Unified Computing System？（）
A . An interface ’san-port-channel’ in NXOS
B . An interface ’port-channel’ in NXOS
C . An interface ’port-channel’ with ’mode fc’ configured
D . An interface ’fc-port-channel’ in NXOS
-
Which mode allows you to configure the B-ACD service provided in Cisco Unified CallManager Express?（）
A . Tcl
B . telephony
C . application
D . IP-telephony
E . telephony-service&e
-
How many VLANs on the UCS must be configured when using FCoE?（）
A . One per blade
B . One per VSAN
C . One per fabric
D . None are required
-
What is the maximum amount of Cisco Agent Desktop downtime after a failover when using highavailability in Cisco Unified Contact Center Express 4.0?（）
A . 10 seconds
B . 30 seconds
C . 45 seconds
D . 60 second
-
What is the maximum number of network locales that can be configured for any one Cisco Unified CallManager Express when using the cnf-file perphone command?（）
A . 1
B . 2
C . 4
D . 5
E . a number equal to the number of languages supported by Cisco Unity Express
F . a number equal to the number of languages supported by Cisco Unity CallManager Expre
-
Which configuration should be done in order to improve the performance of the Cisco Unified Wireless IP Phone 7921G in a WLAN infrastructure?（）
A . enable aggressive load balancing
B . enable coverage hole detection
C . disable dynamic transmit power control
D . enable short preamble
-
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
A . Wireless Control System
B . wireless clients
C . wireless controllers
D . controller-based access points
E . Location Appliance
-
Which two range descriptions correctly describe IP addressing to use when enabling multicast support using the Cisco Unified Wireless Solution?（）
A . globally scoped address range
B . 239.0.0.X or 239.128.0.X address range
C . administratively scoped address range that does not overlap with a link-local MAC address
D . any Class D address range
E . site-local scoped address range
-
When configuring private VLANs， which configuration task must you do first？（）
A . Configure the private VLAN port parameters.
B . Configure and map the secondary VLAN to the primary VLAN.
C . Disable IGMP snooping.
D . Set the VTP mode to transparent.
-
What should you set the Client Configuration to when configuring the ODBC Data Source for the Database Subsystem?（）
A . TCP/IP
B . Multiprotocol
C . Named Pipes
D . NWLink IPX/SPX
-
When configuring system state conditions with the Cisco SecurityAgent， what is the resulting action when configuring more than one system state condition？ （）
A . Any matching state condition will result with the state being triggered
B . Once a state condition ismet， the system ceases searching further conditions and will cause the state condition to trigger
C . All specified state conditions are used as part of the requirements tobe met to for the state to trigger
D . Once the state conditions are met， they become persistent and can only be removed using the Reset feature
-
When configuring SSH， which is the Cisco minimum recommended modulus value？（）
A . 2048 bits
B . 1024 bits
C . 256 bits
D . 512 bit
-
Which two CRM servers allow Cisco Unified Call Connector to be configured for connectivity？（）
A . Siebel
B . Microsoft Dynamics
C . ACT!
D . Salesforce.com
E . Oncontact
-
When using the partially automated setup process, which three tasks must be completed in order to register phones with Cisco Unified CallManager Express?（）
A . Configure the keepalive timer.
B . Associate each phone type with a firmware file.
C . Enable the firmware for each phone type being downloaded.
D . Configure the dial-plan pattern to associate extensions with fully qualified e.164 numbers.
E . Configure the maximum number of ephones that Cisco Unified CallManager Express will support.
F . Configure an ephone for each phone being registered with the Cisco Unified CallManager Express server.
-
Where are CTI route points added or configured for Cisco Unified Contact Center Express? （）
A . Cisco Unified CallManager Device Configuration
B . Cisco Unified Contact Center Express Directory Management
C . Cisco Supervisor Desktop
D . Cisco CRS Administration, JTAPI Trigger Creation
E . Cisco Unified Contact Center Express Media Subsystem&e
-
Which does not need to be configured on ZXCTN6100 when performing basic configuration
A．A.UNI interface configuratio
B．B.Static MAC configuratio
C．C.configuratio
D．D.VLAN interface configuratio
