Prior to running the hydraulic pump, examine the system carefully and ensure that the lever of control valves is in () position.
A . neutral
B . end
C . opening
D . closure
相似题目
-
What must be configured on the Cisco Unity Express host router prior to installation of the CUE module?()
A . Set up the Network Time Protocol server.
B . Install the files needed to run the web-based GUI.
C . Set up routing and IP addressing on the service module and the interface service engine.
D . Configure a session initiation protocol dial peer for connecting calls to the voice mail and Auto Attendant features.
-
If you()a conflict prior to the meeting, discuss the issue with participants in advance.
A . anticipate
B . participate
C . preserve
D . announce
-
Prior to closing the breaker when paralleling two AC generators, the recommended practice is to have the frequency of the incoming machine ()
A . slightly less than the line frequency
B . the same as the line frequency
C . slightly greater than the line frequency
D . All of the above
-
Prior to starting an AC generator prime mover, the voltage regulator cutout switch should be placed in the ()
A . manual position
B . bus neutral position
C . raise voltage position
D . transfer positio
-
Prior to taking over the deck watch in port,the relieving officer shall not be informed by the officer in charge of the deck watch as to().
A . the depth of the water at the berth
B . the ship‟s draught
C . the duty of the relieving officer
D . the arrangement of anchor and the scope of the anchor chai
-
Prior to lowering the lifeboat,the most important item to check is the().
A . oars
B . sail
C . boat plug
D . life preserver
-
Which service component in the implement phase is typically performed prior to the handover of a wireless solution to the customer’s operations organization?()
A . systems integration
B . skill assessment
C . systems acceptance testing
D . wireless check
E . project close out
-
Which of the following statements represents the FIRST precaution to be taken prior to working on any installed electrical component ()
A . Wear rubber gloves and boots
B . Use only approved non-conducting tools
C . Ground the case of the machine before beginning any repairs
D . Open the supply circuits and tag the switche
-
Which of the following procedure should be performed prior to delivery and generally involves running a suite of operations so as to verify that the solution is applicable for production?()
A . Security Check
B . Acceptance Testing
C . Project Close Out
D . Systems Integratio
-
A heater in the circuit facilitates warning of the engine prior to () by circulating hot water.
A . starting
B . stopping
C . to start
D . to sto
-
Prior to getting underway,the Master or person in charge of a ship must().
A . conduct a fire drill
B . conduct a boat drill
C . log the fore and aft draft marks
D . test the emergency generator
-
Which parameter allows SQL*Loader to load data into a table with the indexes in the unusable state, prior to the load operation?()
A . INDEXES
B . SKIP_INDEXES_MAINTENANCE
C . SKIP_UNUSABLE_INDEXES
D . RESUMABLE
E . INDEXES_UNUSABLE
-
Prior to getting underway in fresh or brackish water,the Master must().
A . log the density of the water
B . secure all overboard discharges
C . take on fresh water ballast
D . clean the sides with fresh water
-
Prior to implementing an LPAR system, which of the following needs to be done?()
A . A graphics monitor must be attached to the server
B . Cluster System Management (CSM) software must be installed
C . The LPAR system must have an Hardware Management Console (HMC) connected
D . Each LPAR must be configured with a CDROM for operating system installatio
-
Which of the following should always be checked prior to starting a diesel engine?()
A . Air filters
B . Fuel oil strainers
C . Crank case oil level
D . Pyrometer reading
-
About two hours prior to takeoff, the gate attendant will announce the boarding time.
-
If either party wants to renew the contract, it should submit a written notice to the other party three months prior to the expiration of the contract.
-
The words “prior to”(para.2) probably mean______.
-
The offer is suject to prior sale.
-
Mexican negotiators emphasize relational concerns prior to the real negotiation.
-
Payment is to be made on a six-month ___, with the first payment to be effected fifteen days prior to the date of shipment.
A.basis
B.basic
C.base
D.based
-
Lili Ltd commenced trading on 1 January 2015. The company incurred the following expenditure prior to 1 January 2015:
<img src='https://img2.soutiyun.com/ask/uploadfile/10614001-10617000/5d0077ba1b9e739b01e77bc459ed2dc0.png' />
What is the amount of Lili Ltd’s deductible pre-trading expenditure in respect of the year ended 31 December 2015?
A.£10,000
B.£14,000
C.£27,000
D.£29,000
-
In accounting for a defined benefit pension plan, the amount reported as “prior service cost” refers to the:
A.total value of benefits already paid to retirees who are still receiving pension payments.
B.present value of the pension benefits due to employees based on their employment up to the date of the statement.
C.present value of the increase in future pension benefits from a change in the terms of the pension plan.
-
Prior to fertilization, the egg’s electrical charge is positive.()