Which is true about OSPF router-id?()
Refer to the exhibit.If the router Cisco returns the given output and has not had its router ID set manually, what value will OSPF use as its router ID?()https://assets.asklib.com/images/image2/2018072411242431760.jpg
Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this RouterD?()https://assets.asklib.com/images/image2/2018072408582679930.jpg
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()
在OSPF网络中,以下关于Router ID描述不正确的是()。
如果忘记配置OSPF的router id,则设备缺省下的router id为Loopback最大的地址;如果没有配置Loopback地址,则router id为数值最小的物理接口地址。
What is the purpose of the OSPF router ID in a OR/BOR election?()
Which statement describes the process ID that is used to run OSPF on a router ?()
关于OSPF中Router ID的论述哪个是正确的()。
如果路由器思科返回给定的输出,并没有自己的Router ID手动设置,将使用OSPF作为其路由器ID是什么值?()https://assets.asklib.com/images/image2/2018072316465953766.jpg
请匹配正确的答案()命令可以查看当前路由器配置OSPF的情况:路由器的标识(router id),区域状态,接口状态,引入的外部路由情况等
在OSPF网络中,如果在AS中不同的路由器使用相同的Router ID,会造成OSPF计算混乱。以下命令可以检测到Router ID冲突的是()。
以下关于在OSPF协议中,Router LSA的Link ID字段描述不正确的是?()
每个运行OSPF的路由器都有一个router id,该router id必须在ospf中进行发布
网络管理员正在尝试添加一个新的路由器成为一个既定的OSPF网络。附连到新的路由器的网络不出现在其他OSPF路由器的路由表。考虑到如下图所示的部分配置信息,什么样的配置错误导致这个问题?() Router(config)#router ospf 1 Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
The following was issues on router TestKingA: TestKingA #show ip ospf neighbor Neigbor ID PRI State Dead Time Address Interface 192.168.1.2 1 Full/- 00:00:37 192.168.1.2 Serial1 Which type of OSPF network will provide the output shown in the graphic?()
问题:574OSPFv3 的 Router ID 长度为多少 bit()
OSPF进程的Route ID修改后立即生效
路由器使用Router-ID生成IS-IS进程NET地址的益处有()。
The following was issues on router TestKingA:TestKingA show ip ospf neighborNeigbor ID PRI State Dead Time Address Interface192.168.1.2 1 Full/- 00:00:37 192.168.1.2 Serial1Which type of OSPF network will provide the output shown in the graphic?()
2、对于运行OSPF协议的路由器来说,Router ID是路由器的唯一标识,所以协议规定:必须保证Router ID在如下范围之内唯一________
35、哪条命令可用于检查 OSPF 进程 ID、路由器 ID,路由器正在通告的网络、路由器正在从其接收更新的邻居以及默认管理距离?
在OSPF协议中,每台路由器都有一个Router ID标识,请问路由器选择Router ID的依据是()
路由器使用Router-ID生成IS-IS进程NET地址的益处有()