Which of these commands can you use to show if an operational Catalyst switch port is set for autonegotiation of speed and duplex when running Cisco IOS software?（）
Which mechanism can you use to achieve sub-second failover for link failure detection when a switched Ethernet media is used and loss of signal is not supported by the link provider？（）
When using Cisco Network Assistant to configure a WS-CE500-24LC switch， which three are available choices in the port settings window？（）
When the Catalyst switch R1 is enabled to use VTP， which information does it advertise on its trunk ports？（）
What is one of the reasons that custom QoS ACLs are recommended over automatic QoS when configuring ports on a Catalyst 6500 for use with IP phones?（）
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals？（）
What value is primarily used to determine which port becomes the root port on each non root switch in a spanning-tree topology?（）
Which are valid modes for a switch port used as a VLAN trunk (Choose three.)（）。
How is NIC teaming configured when port channels are not in use in a Cisco Nexus 1000V?（）
What value is primarily used to determine which port becomes the root port on each nonroot switch in aspanning-tree topology？（）
Two Company switches are connected via a trunk using VTP. Which VTP information does a Catalyst switch advertise on its trunk ports when using VTP？（）
A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffic. What is the effect of adding switch ports to a new VLAN on the switch?（）
What is valid reason for a switch to deny port access to new devices when port security is enabled?（）
When NIC teaming is used ,how are loops avoided in a virtual switch?（）
Which three connection options are available when configuring a switch port to be part of a privateVLAN? （）(Choose three.)
When configuring port security on a Cisco Catalyst switch port， what is the default action taken by the switch if a violation occurs？ （）
While installing a new IBM System Storage DS5100 into a customer’s data center， it is discoveredthat the customer does not have enough available Fibre Channel ports on their switches. Which ofthe following should have been used to avoid this situation？（）
Which are valid modes for a switch port used as a VLAN trunk?（）
When NIC teaming is used, how are Loops avoided in a virtual switch?（）
Which are valid modes for a switch port used as a VLAN trunk? (Choose three.)（）
When you enter the interface command auto qos voip cisco-phone on a port at the edge of a network,how does the Cisco Catalyst switch detect if a Cisco IP Phone is connected to the port?（）
When configuring a routed port on a Cisco multilayer switch， which of these is a required configuration task that you must perform to enable that port to function as a routed port？ （）
After enabling port security on a Cisco Catalyst switch， what is the default action when the configuredmaximum of allowed MAC addresses value is exceeded？（）
When configuring unified ports on a 5548 switch， which port ordering must be respected？（）
