By night，you sight the lights of a vessel engaged in underwater operations. If an obstruction exists on the port side of the vessel，it will be marked by（）.
Which of these commands can you use to show if an operational Catalyst switch port is set for autonegotiation of speed and duplex when running Cisco IOS software?（）
Refer to the exhibit. From the MAC addresses shown in the command output， to which two ports is the multicast stream 225.230.57.199 being forwarded on this switch？ （）https://assets.asklib.com/images/image2/2018072317400843243.jpg
Refer to the exhibit.From the MAC addresses shown in the command output，to which two ports is the multicast stream 225.230.57.199 being forwarded on this switch？（）https://assets.asklib.com/images/image2/2018072317362091835.jpg
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）
Which two of the following statements describe a routed switch port on a multilayer switch？（）
When using Cisco Network Assistant to configure a WS-CE500-24LC switch， which three are available choices in the port settings window？（）
Which term describes a spanning-tree network that has all switch ports in either the blocking or forwardingstate？ （）
What value is primarily used to determine which port becomes the root port on each non root switch in a spanning-tree topology?（）
What value is primarily used to determine which port becomes the root port on each nonroot switch in aspanning-tree topology？（）
Which port state is interface Fa0/2 of switch 2 in for VLANs 1 and 160？ （）
While deploying a new switch， you accidently connect ports 3/12 and 3/18 together， creating a loop. STP detected it and placed port 3/18 in blocking mode. Why did STP not place port 3/12 in blocking mode instead？ （）
A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffic. What is the effect of adding switch ports to a new VLAN on the switch?（）
Refer to the topology shown in the exhibit. Which ports will be STP designated ports if all the links are operating at the same bandwidth? （）https://assets.asklib.com/images/image2/201807231709263903.jpg
A customer has a Fibre Channel switch residing in a configuration where both production and test data coexist. Which of the following is the simplest method for ensuring that the two types of data do not flow through the same port?（）
When creating a role in a Cisco Nexus 7000 Series Switch， rules are used to define the type of operations that a role will allow the user to perform. Which two of these parameters cannot be applied as a rule？ （）
A media failure has occurred. This has resulted in all the members of the next log group being rendered inaccessible to the log writer process （LGWR） at a log switch. How does this failure affect the operational database？（）
When configuring port security on a Cisco Catalyst switch port， what is the default action taken by the switch if a violation occurs？ （）
Select the action that results from executing these commands. Switch（config-if）# switchport port-security. Switch（config-if）# switchport port-security mac-address sticky（）
pany is implementing 802.1X in order to increase network security. In the use of 802.1X access control， which three protocols are allowed through the switch port before authentication takes place？ （）
The plunger in a jerk pump is rotated until the release port is uncoveredIf the port remains uncovered all of the time, which of the listed operations will occur?（）
Refer to the exhibit. From the MAC addresses shown in the command output， to which two ports is the multicast stream 225.230.57.199 being forwarded on this switch？ （）https://assets.asklib.com/images/image2/201807240909385063.jpg
While deploying a new switch， you accidently connect ports 3/12 and 3/18 together， creating a loop. STP detected it and placed port 3/18 in blocking mode. Why did STP not place port 3/12 in blocking mode instead？（）
When configuring unified ports on a 5548 switch， which port ordering must be respected？（）
