-
On a WLAN controller，what is the default roaming bandwidth percentage reserved for voice clients？（）
A . 12 percent
B . 6 percent
C . 18 percent
D . 24 percent
-
Which command will enable dhcp debugging on a wlan controller？（）
A . debug dhcp enable
B . debug dhcp status enable
C . debug dhcp packet enable
D . enable debug dhcp packet
-
What is the maximum number of wlan controllers that can join a single mobility group？（）
A . 48
B . 36
C . 12
D . 24
-
what is IOS feature limit or controls traffic on a catalyst interface？
-
By default， on the WLAN controller for a voice application using Cisco 7921 wireless IP phones. What is the percentage of RF bandwidth that can be dedicated to the phones？（）
A . 75 percent
B . 85 percent
C . 56 percent
D . 55 percent
-
On a Cisco 1000 Series controller-based access point， the alarm LED is flashing red， but the otherLEDs are off. What is this access point indicating？（）
A . Its IP address already exists.
B . It is operating normally.
C . It requires a code upgrade.
D . It has lost contact with the controller.
-
When using simultaneous voice and multicast on a single WLAN and RF band, what is the recommended DTIM value of the WLAN for VoWLAN devices?（）
A . DTIM = 1
B . DTIM = 2
C . DTIM = 3
D . DTIM = 4
-
What level of control does a subflow have on the overall contact?（）
A . The subflow cannot call additional or "nested" subflows.
B . The subflow cannot transfer the contact to another resource.
C . The subflow has full contact control and can perform any action that the parent flow can perform.
-
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped. What may cause this problem？（）
A . The minimum data rate is not set to 11 Mbps.
B . An address resolution protocol is enabled.
C . Publicly Secure Packet forwarding is enabled.
D . The access point is set to the least congested channel.
-
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN. What may cause this problem？（）
A . The minimum data rate is not set to 11 Mbps.
B . An address resolution protocol has been disabled
C . Publicly Secure Packet forwarding is enabled
D . The access point is set to the least congested channel.
-
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN. What may have caused this problem？（）
A . The minimum data rate is not set to 11 Mbps.
B . Publicly Secure Packet forwarding is enabled.
C . The access point is set to the least congested channel.
D . An address resolution protocol has been disabled.
-
An Active Directory database is installed on the C volume of a domain controller. You need to move the Active Directory database to a new volume What should you do（）
A . Move the ntds，dit file to the new volume by using Windows Explorer.
B . Copy the ntds，dit file to the new volume by using the ROBOCOPY command.
C . Move the ntds，dit file to the new volume by using the Files option in the Ntdsutil utility .
D . Move the ntds，dit file to the new volume by running the Move-item command in Microsoft Windows powerShell.
-
You network consists of a single Active Directory domain. All domain controllers run Windows Server 2008 R2. You need to reset the Directory Services Restore Mode （DSRM） password on a domain controller. What tool should you use（）
A . dsmod
B . ntdsutil
C . Local Users and Groups snap-in
D . Active Directory Users and Computers snap-i
-
In CRS Administration, when you add a JTAPI Call Control Group, what is created on the Cisco CallManager?（）
A . CallManager Call Control Group
B . CRS CTI Route Point
C . CRS JTAPI User
D . CTI ports
E . CRS Call Control Group
F . CTI Route Points and directory numbers&e
-
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN. The phonerings but， when you answer， the call is dropped. What may have caused this problem？（）
A . The minimum data rate is not set to 11 Mbps.
B . An address resolution protocol is enabled.
C . Publicly Secure Packet forwarding is enabled.
D . The access point is set to the least congested channel.
-
Which of the general policies on the wlan edit page on the wlan controller would be used when configuring a radio for a single antenna for an outdoor application？（）
A . 802.11b/g
B . radio
C . access point
D . 802.11a
-
Your company has a single Active Directory domain. All domain controllers run Windows Server 2003. You install Windows Server 2008 R2 on a server. You need to add the new server as a domain controller in your domain. What should you do first（）
A . On the new server， run dcpromo /adv.
B . On the new server， run dcpromo /createdcaccount.
C . On a domain controller run adprep /rodcprep.
D . On a domain controller， run adprep /forestprep.
-
By default， on the WLAN controller for a voice application using Cisco 7921 wireless IP phones， what is thepercentage of RF bandwidth that can be dedicated to the phones？（）
A . 55 percent
B . 56 percent
C . 75 percent
D . 85 percent
-
You are troubleshooting a one-way call problem with a cisco 7920 wireless ip phone on a standalone wlan. What may cause this problem？（）
A . the minimum data rate is not set to 11 mbps.
B . an address resolution protocol has been disabled
C . publicly secure packet forwarding is enabled
D . the access point is set to the least congested channel.
-
Which of the general policies on the WLAN edit page on the WLAN controller would be used when configuring a radio for a single antenna for an outdoor application？（）
A . 802.11b/g
B . radio
C . access point
D . 802.11a
-
By default，on the wlan controller for a voice application using cisco 7921 wireless ip phones. what is the percentage of rf bandwidth that can be dedicated to the phones？（）
A . 75 percent
B . 85 percent
C . 56 percent
D . 55 percent
-
You network consists of a single Active Directory domain. All domain controllers run Windows Server 2008. You need to reset the Directory Services Recovery Mode （DSRM） password on a domain controller. What tool should you use（）
A . dsmod
B . ntdsutil
C . Local Users and Groups snap-in
D . Active Directory Users and Computers snap-i
-
You are troubleshooting a one-way call problem with a cisco 7920 wireless ip phone on a standalone wlan. What may have caused this problem？（）
A . the minimum data rate is not set to 11 mbps.
B . publicly secure packet forwarding is enabled.
C . the access point is set to the least congested channel.
D . an address resolution protocol has been disabled.
-
Which statement describes the WLCv5.2 delivery of a multicast packet from a wired PC source on VLAN_X to a respective wireless client using SSID_X, using a WLAN controller enabled for multicast?（）
A . A packet is delivered to Cisco WLC and forwarded via multicast to all of its associated APs, and finally to all wireless clients of that Cisco WLC, via wireless multicast.
B . A packet is delivered to Cisco WLC and forwarded via unicast to all of its associated APs, and finally to all wireless clients of that Cisco WLC, via wireless unicast.
C . A packet is delivered to Cisco WLC and forwarded via multicast to all of its associated APs, discarded at APs without SSID_X joined wireless clients, and forwarded at APs with SSID_X joinedwireless clients via wireless multicast.
D . A packet is delivered to Cisco WLC and forwarded via unicast to all of its associated APs, discarded at APs without SSID_X joined wireless clients, and forwarded at APs with SSID_X joined wireless clients via wireless multicast.
E . A packet is delivered to Cisco WLC and forwarded via multicast to all of its associated APs, discarded at APs without SSID_X joined wireless clients, and forwarded at APs with SSID_X joinedwireless clients via wireless unicast.
F . A packet is delivered to Cisco WLC and forwarded via unicast to all of its associated APs, discarded at APs without SSID_X joined wireless clients, and forwarded at APs with SSID_X joined wireless clients via wireless unicast.
