The actual rudder angle reading is（）
A twin-screw vessel with a single rudder is making headway. The engines are full speed ahead. There is no wind or current. Which statement is FALSE? （）
Ease the rudder means to（）.
Owing to the greater girth of a ship amidships than at the ends，certain strakes are dropped as they approach the bow and stern to reduce the amount of plating at the ends. These strakes are called（）.
（）is from baseline to top of the upper deck breadth at the ship’s side amidships.
The projecting lugs of the rudderpost which furnish support to the rudder are called（）.
Special thrust devices are provided on ships to improve their （） at zero ship speed when the rudder is relatively ineffective.
When backing a motor propelled lifeboat (right-hand propeller) with the rudder amidships，the stern will back（）.
You are standing the wheelwatch on entering port and the Master gives you a rudder command which conflicts with a rudder command from the Pilot.What should you do（）.
The transmission system is the means （）the movement of the rudder is accomplished.
Keel scantlings of any vessel are greatest amidships because（）.
If a heavy sea strikes the rudder, the shock is transmitted through the tiller to （）.
Flanking rudders effect a vessel’s heading because of the（）.
You are backing on twin engines with rudders amidships，when your port engine stalls.To continue backing on course，you should（）.
When the helm demands a 20°right rudder movement from an electro-hydraulic steering gear, which of the listed actions will be the FIRST action to happen when this rudder position is attained?（）
The required rudder angle is transmitted hydraulically or electrically from the steering wheel at the bridge to the （）at the steering gear, just above the rudder.
In a Williamson turn，the rudder is put over full until the（）.
The horizontal flat surfaces where the upper stock joins the rudder are the（）.
Rudder position is shown on the bridge by the（）
While you are on watch entering port，the Master gives the helmsman a rudder command which conflicts with a rudder command from the Pilot.You should make sure the helmsman（）.
0111The transmission system is the means ______ the movement of the rudder is accomplished.
The rudders are amidships and both screws are going ahead．What will happen if the starboard screw is stopped ________．
You are on a single-screw vessel with a right-handed propeller.The vessel is going full speed astern with full right rudder.The bow will swing ______.
