An anemometer on a moving vessel measures（）.
（）is the process by which the position of the vessel at any moment is found by applying the last well-determined position to the run that has been made since，using for this purpose the ship’s course and the distance being those indicated by log.
For an upright vessel, draft is the vertical distance between the keel and the （）.
In stopping distances of vessels，head reach can best be described as the（）.
MOVING OF AN ANCHOR OVER THE SEA BOTTOM INVOLUNTARILY BECAUSE IT IS NO LONGER PREVENTING THE MOVEMENT OF THE VESSEL defines（）.
The distance that a ship moves forward with each revolutionof its propeller，if there is no slip，is called（）.
As a vessel falls off the wind from close-hauled to a beam reach，the tendency for the vessel to move sideways through the water will（）.
For an upright vessel，draft is the vertical distance between the keel and the（）.
A vessel is proceeding downstream in a narrow channel on the Western Rivers when another vessel is sighted moving upstream. Which vessel has the right of way? （）
The distance a vessel moves parallel to the original course from the point where the rudder is put over to any point on the turning circle is called the（）.
Moving of an anchor over the sea bottom involuntarily because it is no longer preventing the movement of the vessel defines（）.
What is the MINIMUM distance a vessel subject to the requirements of Annex V to MARPOL 73/78 must be located from nearest land to legally discharge paper trash?（）
All vessels at mooring（）move to the sheltered anchorage.
A mooring line that prevents a vessel from moving sideways away from the dock is a（）.
Acknowledgement by you of receipt of a distress message from a vessel which，beyond any possible doubt，is not in your vicinity and is a long distance away must be made when（）.
To increase the distance to the vessel ahead by reducing one’s own speed means（）.
A stream of water immediately surrounding a moving vessel’s hull，flowing in the same direction as the vessel is known as（）.
Moving of an anchor over the sea bottom to control the movement of the vessel defines（）.
0n a vessel,multipiying a load’s weight by the distance of the load’s center of gravity above the baseline results in a(n)（）.
The height of a wave is the vertical distance（）.
A sailing vessel is overtaking a power-driven vessel in a narrow channel，so as to pass on the power-driven vessel’s port side. The overtaken vessel will have to move to facilitate passage. The sailing vessel is the（）.
98. Which weather element cannot be measured accurately while on board a moving vessel?
MOVING OF AN ANCHOR OVER THE SEA BOTTOM TO CONTROL THE MOVEMENT OF THE VESSEL defines ______.
Aboard a vessel, multiplying a load’s weight by the distance of the load’s center of gravity from the mid-ship section results in the load’s ______.
