-
When BGP is used as the PE-CE routing protocol, which of these statements is correct?（）
A . On the CE router, PE neighbors must be configured in the VRF context on the CE router
B . On PE routers, the CE IBGP neighbors are configured in the global BGP configuration
C . On PE routers, the CE EBGP neighbors are configured in the VRF context
D . A separate BGP process must be used on the PE routers for CE routers so that they do not use the same BGP routing process as that used for the PE router's other provider neighbor
-
ou are the Cisco Network Designer in Cisco.com. Which of these practices should you followwhen designing a Layer 3 routing protocol？（）
A . Never peer on transit links.
B . Build squares for deterministic convergence.
C . Build inverted U designs for deterministic convergence.
D . Summarize routes at the distribution to the core to limit EIGRP queries or OSPF LSA propagation.
-
Which two design recommendations are most appropriate when OSPF is the data center core routing protocol? （）
A . Never use passive interfaces.
B . Use NSSA areas from the core down.
C . Use totally stub areas to stop type 3 LSAs.
D . Use the lowest Ethernet interface IP address as the router ID.
E . Tune OSPF timers to enable OSPF to achieve quicker convergence.
-
Which agent will be selected when the Resource Selection Criteria is set to circular routing?（）
A . the agent who has been in the Available state for the longest amount of time
B . the next available agent with the highest priority, as determined by the agent order in the Resources list
C . the next available agent, based on the last agent selected and the agent order in the Resources list
D . the agent assigned to the selected Resource Group and is thus qualified to be selected
-
Inter-VLAN routing has been implemented in the Company network. In VLAN routing， what are some of the disadvantages of designing a router-on-stick configuration？ （）
A . InterVLAN routing cannot be filtered by the router.
B . The router becomes a single point of failure for the network.
C . Routers will not route STP BPDUs.
D . There is a possibility of inadequate bandwidth for each VLAN.
E . Additional overhead on the router can occur.
F . NetFlow Switching is required for InterVLAN accounting.
-
which one of the following database elements is not updated when the design task is run?（）
A . forms
B . views
C . roles
D . agent
-
Which two design recommendations are most appropriate when OSPF is the data center core routing protocol？ （）
A . Never use passive interfaces.
B . Use NSSA areas from the core down.
C . Use totally stub areas to stop type 3 LSAs.
D . Use the lowest Ethernet interface IP address as the router ID.
E . Tune OSPF timers to enable OSPF to achieve quicker convergence
-
Router R1 sets a route tag for subnet 10.1.1.0/24 when redistributing from OSPF into EIGRP.Which of the following unit is assigned to the route tag?（）
A . Kilobits/seconD
B . Tens of microseconds
C . Cost
D . Hop count
E . No unit is assigneD
-
What are three relevant design considerations when using the 15216 EDFA？（）
A . dispersion
B . Optical SNR
C . span attenuation
D . four wave mixing
E . receiver sensitivity
-
You need to design the configuration of the Windows Server 2003 Routing and Remote Access server in the Seattle office to meet business requirements. What should you do？（）
A . Configure a remote access policy on the Routing and Remote Access server to require MS-CHAP v2 for all connections
B . Use a Group Policy object （GPO） to configure a Restricted Groups policy that applies to the Routing and Remote Access server. Use this Restricted Groups policy to remove all accounts form the local Users group， and then add authorized computer accounts
C . Configure the Routing and Remote Access server to use only PPTP connections
D . Configure the Routing and Remote Access server to use only IPSec over L2TP connections.Configure IPSec to use certificate
-
When EIGRP is used as the PE-CE routing protocol which of these statements is correct?（）
A . EIGRP can be used only as the PE-CE routing protocol if the PE and CE routers are in the same AS
B . Other EIGRP AS routes are automatically advertised to the CE router and do not require a redistribution configuration command to be configured
C . Unlike other routing protocols that are used between PE and CE routers, EIGRP supports backdoor links
D . Configure of the VPN is only required on the PE router
-
The Testking router is running both RIP and IGRP, and the same route is learned by this router from both of these methods. However, when you issue the command"show ip route" you see only the IGRP route, and not the RIP route. Why is this?（）
A . IGRP has a faster update timer.
B . IGRP has a lower administrative distance.
C . RIP has a higher metric value for that route.
D . The IGRP route has fewer hops.
E . The RIP path has a routing loop.
-
Which of the following routing protocols are less likely prone routing loops and network reachability problems when used in discontiguous networks?（）
A . IGRP
B . CDP
C . OSPF
D . RIP v1
E . RIP v2
F . EIGRP
-
Which two design recommendations are most appropriate when EIGRP is the data center core routing protocol?（）
A . Summarize data center subnets.
B . Use passive interfaces to ensure appropriate adjacencies.
C . Tune the EIGRP timers to enable EIGRP to achieve quicker convergence.
D . Adjust the default bandwidth value to ensure proper bandwidth on all links.
E . Advertise a default summary route into the data center core from the aggregation layer.
-
You are the Cisco Network Designer in Cisco.com. You are designing an e-Commerce module，which routing statement is correct？（）
A . Routing is mostly static.
B . Hardcoded IP addresses are used to support failover.
C . Inbound servers use the CSM or ACE as the default gateway.
D . VLANs between the access layer switches are used for FHRP protocols.
-
When policy - based routing (PBR) is being configured, which three criteria can the set command specify?（）
A . all interfaces in the path toward the destination
B . all networks in the path toward the destination
C . adjacent next hop router in the path toward the destination
D . all routers in the path toward the destination
E . all interfaces through which the packets can be routed
F . type of service and precedence in the IP packet
-
When an Enterprise Campus network designer is addressing the merger of two companies with different IGPs， which of the following is considering a super routing design？（）
A . Eliminate the management and support for redistribution by choosing and cutting over to asingle IGP at the time of merger
B . Maintain distinct pockets across a moving boundary of routing protocols， redistributing betweenthem
C . Manipulate the administrative distance of the different IGPs to be equal throughout the network
D . Leave the IGPs independent without redistribution wherever communication between companyentities is not required
-
When designing the IP routing for the Enterprise Campus network， which of these following twoiBGB considerations should be taken into account？（）
A . iBGB dual horning with different iSPs puts the Enterprise at the risk of becoming a transitnetwork
B . iBGP requires a full mesh of eBGP peers
C . Routers will not advertise iBGP learned routers to other iBGP peers.
D . The use of route reflections or Confederation eliminate any full mesh requirement while helpingto scale iBGP
E . iGBP peers do not add any information to the AS path
-
You are the Cisco Network Designer in Cisco.com. You are designing an e-Commerce module, which routing statement is correct?（）
A . Routing is mostly static.
B . Hardcoded IP addresses are used to support failover.
C . Inbound servers use the CSM or ACE as the default gateway.
D . VLANs between the access layer switches are used for FHRP protocols.
-
What are three relevant design considerations when using the 15216 EDFA? （）(Choose three.)
A . dispersion
B . Optical SNR
C . span attenuation
D . four wave mixing
E . receiver sensitivity
-
What kind of elements should be included when we are designing the itinerary?
A、Number of the tourists.
B、Tour destination.
C、Traveling season or time.
D、Traveling budget.
-
Given the following policy, what happens when the 1.1/17 route is evaluated？（）
<img src='https://img2.soutiyun.com/shangxueba/ask/17124001-17127000/17125954/deb7ed68c2d7e927abdb1c3b0d607a7b.jpg' />
<img src='https://img2.soutiyun.com/shangxueba/ask/17124001-17127000/17125954/42e9c457823b57ebe153d61d4f5b09e9.jpg' />
A. The route does not match this policy.
B. The route is accepted.
C. The route is rejected.
D. The route is accepted with a metric of 6.
-
When we design the mechatronic product, what types of design ideas can we apply？
A．developmental design
B．adaptive design
C．variant design
D．normal design
E．electromechanical complementary method
-
Given the following policy:Which action occurs when the static route 192.168.0.0/25 is evaluated by the policy main-policy？（）
<img src='https://img2.soutiyun.com/shangxueba/ask/17124001-17127000/17125950/8e2fb3fa4143bed57b6b954cc1553b4c.jpg' />
<img src='https://img2.soutiyun.com/shangxueba/ask/17124001-17127000/17125950/265fc01b1b80240718f8c4374783c453.jpg' />
A. The route is not advertised into BGP.A.The route is not advertised into BGP.
B. The route is advertised into BGP with metric 10.B.The route is advertised into BGP with metric 10.
C. The route is advertised into BGP with metric 20.C.The route is advertised into BGP with metric 20.
D. The route is advertised into BGP with default metric.D.The route is advertised into BGP with default metric.
