-
ou are the Cisco Network Designer in Cisco.com. Which of these practices should you followwhen designing a Layer 3 routing protocol？（）
A . Never peer on transit links.
B . Build squares for deterministic convergence.
C . Build inverted U designs for deterministic convergence.
D . Summarize routes at the distribution to the core to limit EIGRP queries or OSPF LSA propagation.
-
When configuring an interface using SMIT and Further Configuration with an IP address and netmask， which of the following outcomes indicates how the routing tables will be affected？（）
A . A subnet route is automatically added
B . A default route is automatically added
C . All other routes are automatically added
D . The routing table is not affected
-
Which two design recommendations are most appropriate when OSPF is the data center core routing protocol? （）
A . Never use passive interfaces.
B . Use NSSA areas from the core down.
C . Use totally stub areas to stop type 3 LSAs.
D . Use the lowest Ethernet interface IP address as the router ID.
E . Tune OSPF timers to enable OSPF to achieve quicker convergence.
-
When designing the routing for an Enterprise Campus network it is important to keep while of thefollowing filtering aspects in mind？（）
A . Filtering is only useful when combined with route summarization
B . It is best to filter （allow） the default and summary prefixes only in the Enterprise Edge to remotesites or site-to-site IPsec VPN networks
C . IGPs （for example EIGRP or OSPF） are superior to route filtering in avoiding in inappropriatetransit traffic through remote nodes or inaccurate or inappropriate routing updates
D . The primary limitation of router filtering is that it can only be applied on outbound update
-
You need to design router redundancy on the Company network. Which three protocols could be chosen for IP routing redundancy to protect against first-hop router failure？（）
A . GLBP
B . ICMP
C . MSTP
D . HSRP
E . VRRP
F . NHRP
-
Which agent will be selected when the Resource Selection Criteria is set to circular routing?（）
A . the agent who has been in the Available state for the longest amount of time
B . the next available agent with the highest priority, as determined by the agent order in the Resources list
C . the next available agent, based on the last agent selected and the agent order in the Resources list
D . the agent assigned to the selected Resource Group and is thus qualified to be selected
-
Inter-VLAN routing has been implemented in the Company network. In VLAN routing， what are some of the disadvantages of designing a router-on-stick configuration？ （）
A . InterVLAN routing cannot be filtered by the router.
B . The router becomes a single point of failure for the network.
C . Routers will not route STP BPDUs.
D . There is a possibility of inadequate bandwidth for each VLAN.
E . Additional overhead on the router can occur.
F . NetFlow Switching is required for InterVLAN accounting.
-
Which two design recommendations are most appropriate when OSPF is the data center core routing protocol？ （）
A . Never use passive interfaces.
B . Use NSSA areas from the core down.
C . Use totally stub areas to stop type 3 LSAs.
D . Use the lowest Ethernet interface IP address as the router ID.
E . Tune OSPF timers to enable OSPF to achieve quicker convergence
-
Router R1 sets a route tag for subnet 10.1.1.0/24 when redistributing from OSPF into EIGRP.Which of the following unit is assigned to the route tag?（）
A . Kilobits/seconD
B . Tens of microseconds
C . Cost
D . Hop count
E . No unit is assigneD
-
What are three relevant design considerations when using the 15216 EDFA？（）
A . dispersion
B . Optical SNR
C . span attenuation
D . four wave mixing
E . receiver sensitivity
-
You need to design the configuration of the Windows Server 2003 Routing and Remote Access server in the Seattle office to meet business requirements. What should you do？（）
A . Configure a remote access policy on the Routing and Remote Access server to require MS-CHAP v2 for all connections
B . Use a Group Policy object （GPO） to configure a Restricted Groups policy that applies to the Routing and Remote Access server. Use this Restricted Groups policy to remove all accounts form the local Users group， and then add authorized computer accounts
C . Configure the Routing and Remote Access server to use only PPTP connections
D . Configure the Routing and Remote Access server to use only IPSec over L2TP connections.Configure IPSec to use certificate
-
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）
A . Route reflectors are not passing updates properly.
B . BGP synchronization has been enabled.
C . The next-hop address is unreachable.
D . No loopback interface has been configured on a router.
-
The Testking router is running both RIP and IGRP, and the same route is learned by this router from both of these methods. However, when you issue the command"show ip route" you see only the IGRP route, and not the RIP route. Why is this?（）
A . IGRP has a faster update timer.
B . IGRP has a lower administrative distance.
C . RIP has a higher metric value for that route.
D . The IGRP route has fewer hops.
E . The RIP path has a routing loop.
-
A network design shows that R1 has four different possible paths from itself to the Data Center subnets. Which one of the following commands is most likely to show you all the possible next - hop IP addresses for these four possible routes?（）
A . show ip eigrp topology
B . show ip eigrp topology all - links
C . show ip route eigrp
D . show ip route eigrp all - links
E . show ip eigrp topology all - learned
-
Which of the following routing protocols are less likely prone routing loops and network reachability problems when used in discontiguous networks?（）
A . IGRP
B . CDP
C . OSPF
D . RIP v1
E . RIP v2
F . EIGRP
-
Which two design recommendations are most appropriate when EIGRP is the data center core routing protocol?（）
A . Summarize data center subnets.
B . Use passive interfaces to ensure appropriate adjacencies.
C . Tune the EIGRP timers to enable EIGRP to achieve quicker convergence.
D . Adjust the default bandwidth value to ensure proper bandwidth on all links.
E . Advertise a default summary route into the data center core from the aggregation layer.
-
You are the Cisco Network Designer in Cisco.com. You are designing an e-Commerce module，which routing statement is correct？（）
A . Routing is mostly static.
B . Hardcoded IP addresses are used to support failover.
C . Inbound servers use the CSM or ACE as the default gateway.
D . VLANs between the access layer switches are used for FHRP protocols.
-
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）
A . R 192.168.8.0/24 [120/1] via 192.168.2.2, 00:00:10, Serial0
B . R 192.168.11.0/24 [120/7] via 192.168.9.1, 00:00:03, Serial1
C . C 192.168.1.0/24 is directly connected, Ethernet 0
D . R 192.168.5.0/24 [120/15] via 192.168.2.2,00:00:10,Serial0
-
When an Enterprise Campus network designer is addressing the merger of two companies with different IGPs， which of the following is considering a super routing design？（）
A . Eliminate the management and support for redistribution by choosing and cutting over to asingle IGP at the time of merger
B . Maintain distinct pockets across a moving boundary of routing protocols， redistributing betweenthem
C . Manipulate the administrative distance of the different IGPs to be equal throughout the network
D . Leave the IGPs independent without redistribution wherever communication between companyentities is not required
-
You are the Cisco Network Designer in Cisco.com. You are designing an e-Commerce module, which routing statement is correct?（）
A . Routing is mostly static.
B . Hardcoded IP addresses are used to support failover.
C . Inbound servers use the CSM or ACE as the default gateway.
D . VLANs between the access layer switches are used for FHRP protocols.
-
Given the following policy, what happens when the 1.1/17 route is evaluated？（）
<img src='https://img2.soutiyun.com/shangxueba/ask/17124001-17127000/17125954/deb7ed68c2d7e927abdb1c3b0d607a7b.jpg' />
<img src='https://img2.soutiyun.com/shangxueba/ask/17124001-17127000/17125954/42e9c457823b57ebe153d61d4f5b09e9.jpg' />
A. The route does not match this policy.
B. The route is accepted.
C. The route is rejected.
D. The route is accepted with a metric of 6.
-
When we design the mechatronic product, what types of design ideas can we apply？
A．developmental design
B．adaptive design
C．variant design
D．normal design
E．electromechanical complementary method
-
A network design shows that R1 has four different possible paths from itself to the Data Center subnets.Which one of the following commands is most likely to show you all the possible next - hop IP addresses for these four possible routes？（）
A. show ip eigrp topology
B. show ip eigrp topology all - links
C. show ip route eigrp
D. show ip route eigrp all - links
E. show ip eigrp topology all - learned
-
Refer to the exhibit. EIGRP had converged in AS 1 when the link between router R1 and R2 went down. The console on router R2 generated the following messages:*Mar 20 12:12:06: %DUAL - 5NBRCHANG E: IP - EIGRP 1: Neighbor 10.1.4.3 (Serial0) is down: stuck in active*Mar 20 12:15:23: %DUAL -3- SIA: Route 10.1.1.0/24 stuck - in - active state in IP - EIGRP 1.Cleaning up The network administrator issued the show ip eigrp topology active command on R2 to check the status of the EIGRP network.Which statement best describes the reason for the error messages？（）
<img src='https://img2.soutiyun.com/shangxueba/ask/64335001-64338000/64337716/48ae99ce89919b8ea814d8bd8606dee0.jpg' />
A. Incorrect bandwidth configuration on router R3 prevents R2 from establishing neighbor adjacency.
B. Incorrect bandwidth configuration on router R 5 prevents R2 from establishing neighbor adjacency.
C. Router R3 did not reply to the query about network 10.1.1.0/24 sent by router R2 .
D. Router R5 did not reply to the query about network 10.1.1.0/24 sent by router R2 .
