在路由器中使用show interface命令,如果看到的结果是接口状态和线路协议状态者是down,可能的原因是()。
如果执行了show interface serial 0命令而且出现了消息“Serial line is up,line protocol is up”,对于这条消息的正确解释是什么?()
检查路由器接口好坏使用show interface命令。
值班主任未收到新株台发来的调度命令,查看CT通信机发现与TDCS和CTC分界口连接中断,查看TDCS和CTC分界口发现程序未运行,将程序运行后CT连接正常,但CTC分界口与TDCS分界口仍未连接,则需要()。
当排除网络故障时,网络管理员在路由器上发出show version命令。使用此命令可以找到哪些信息()。
Router# show interfaces serial 0/1 命令的输出显示了如下内容: Serial0/1 is down, line protocol is down. 线路协议为 down(关闭)的原因最可能是什么()
show ip interface brief命令的作用是()。
TDCS中show interface命令查看路由器接口,如显示Ethernet 0 is up则表示()。
当你通过show ip interface来查看IP地址时,发现接口VLAN1的状态为down,请问可能造成这种情况的原因是?()
华为交换机中,display interface vlan命令用来查看主接口下所有配置指定VLAN ID的子接口或untagged的子接口。
GGSN的端口检查命令是show ip interface brief。()
PTN 设备单站调试中,常用命令show interface brief查询端口三个层面(AdminStatus,PhyStatus,Protocol)下的up/down状态,其中进入相应接口配置模式下,执行shutdown/no shutdown直接影响哪一项的状态?()
Juniper路由器中,在配置模式中可以通过输入哪个字符查看可使用的命令()
思科设备路由表查看方法show ip route。
查看路由器的ARP表的命令是show ip route。
配置Cisco路由器使用show interface 查看时,发现这样一条信息:Ethernet 1 is administratively down,这意味着()。
show interface命令用来查看(),ping命令用来查看(),远程登录的命令是()。
使用“show port-security interface f0/1”命令可查看交换机端口F0/1的安全配置信息。
使用配置命令“enable secret hngy”配置的密码通过命令“show run”可查看得到。
路由器命令Router>show interface的作用是()?
在PTN设备中,用命令show interface all可以检测到所有接口的状态。()
在路由器上使用()命令查看路由表。A.route printB.show ip routeC.show routing-tableD.display i
在ZXCTN设备调试eth接口过程中,我们常用show interface brief命令查询E1口和以太网口是否运转正常,其中,Admin状态的up和down表示 (),Phy状态的up和down表示 (),Prot状态的up和down表示 ()。
哪两条信息会显示在 show ip interface brief 命令的输出结果中?()