-
When designing a single tier AIX database solution for a customer, what other technical specialist would be most instrumental in putting together a total solution and why?()
A . xSeries specialist,as the customer may have some Intel-based systems.
B . Hardware customer engineer,as they will be installing the entire solution.
C . Services specialist,as they can provide education recommendations for the entire solution.
D . Storage specialist,as the customer may need disk to store the data and tape to backup the data.
-
Which two design concerns must be addressed when designing a multicast implementation?()
A . only the low-order 23 bits of the MAC address are used to map IP addresses
B . only the low-order 24 bits of the MAC address are used to map IP addresses
C . only the high-order 23 bits of the MAC address are used to map IP addresses
D . only the low-order 23 bits of the IP address are used to map MAC addresses
E . the 0x01004f MAC address prefix is used for mapping IP addresses to MAC addresses
F . the 0x01005e MAC address prefix is used for mapping IP addresses to MAC addresse
-
When designing an expansion within the same data center, when is a pre-sales TDA absolutely required by IBM?()
A . for a SAN768B Director
B . for a second TS3500 Tape Library
C . for a second EXP5060 Expansion Unit
D . for an additional DS8300 Expansion Frame
-
When designing the routing for an Enterprise Campus network it is important to keep while of thefollowing filtering aspects in mind?()
A . Filtering is only useful when combined with route summarization
B . It is best to filter (allow) the default and summary prefixes only in the Enterprise Edge to remotesites or site-to-site IPsec VPN networks
C . IGPs (for example EIGRP or OSPF) are superior to route filtering in avoiding in inappropriatetransit traffic through remote nodes or inaccurate or inappropriate routing updates
D . The primary limitation of router filtering is that it can only be applied on outbound update
-
When designing the coverage area for high call capacity, what two actions should be done with data rates and channels?()
A . Avoid channels with high AP co-channel interference.
B . Use channels with high AP co-channel interference to avoid channel roams.
C . Set the 2.4-GHz data rate of 5.5 Mb/s to required.
D . Use 5-GHz channels when possible.
E . Use 2.4-GHz channels when possible.
-
At design time, you create a query record group for the LOV associated with the HOTEL text item in a form module for the Travel Planner Application. When is the record group populated?()
A . When the user navigates to the HOTEL item.
B . When the form module successfully compiles.
C . After Form Builder validates the SELECT statement and dismisses the New Record Group dialog box.
D . When the user enters data in the HOTEL item, and the Validate from List property for the HOTEL item is set to YES.&e
-
What are three relevant design considerations when using the 15216 EDFA?()
A . dispersion
B . Optical SNR
C . span attenuation
D . four wave mixing
E . receiver sensitivity
-
A customer needs to implement a Highly Available solution for JMS that has a primary data center and a backup. Which three steps would you perform when designing your solution?()
A . Store Transaction Logs in a database and use Database stores for JMS to make replication between sites easier.
B . Use file based Transaction Logs and JMS stores and implement a separate replication solution for files in addition to database in case database replication fails.
C . Implement Oracle RAC at each site to provide a highly available solution within each datacenter.
D . Configure Whole Server Migration to migrate WebLogic Managed Servers from the primary to the secondary site.
E . Configure Automatic Service Migration for JMS high availability within a datacenter.
-
You need to design a remote access strategy for the customer support users when they work from home. Your solution must meet security requirements. What should you do?()
A . Deploy an L2TP/IPsec VPN server in each call center. Configure the portable computers as L2TP VPN clients
B . Create IPSec tunnel mode connections between the customer support users home and the company’s Internet-facing routers
C . Create IP packet filters on the company’s Internet-facing routers to allow the Remote Desktop Protocol (RDP).Create IPSec filters on the terminal servers to allow only connections that use RDP
D . Create IP packet filters on the company’s Internet-facing routers to allow the IPSec protocols. Assign the Secure Server (Require Security) IPSec policy to the terminal servers. Assign the Client (Respond only) IPSec policy to the portable computer
-
英译中:Design for logistics
-
When you design QoS on CE for an MPLS Layer 2 VPN, which three things should be considered?()
A . Layer 2 access link QoS design
B . enterprise-to-service-provider mapping models
C . Layer 3 link access QoS design
D . service provider service level agreements
E . Layer 2 link access load balancing
-
For many years marine centrifuges were designed for () operation, that is the machines were run for a period during which solids accumulated in the bowlThe machine was stopped when the accumulated solids began to impair its performance.
A、purifying
B、batch
C、long period
D、temporary
-
Which two design concerns must be addressed when designing a multicast implementation?()
A . only the low-order 23 bits of the MAC address are used to map IP addresses
B . only the low-order 24 bits of the MAC address are used to map IP addresses
C . only the high-order 23 bits of the MAC address are used to map IP addresses
D . only the low-order 23 bits of the IP address are used to map MAC addresses
E . the 0x01004f MAC address prefix is used for mapping IP addresses to MAC addresses
F . the 0x01005e MAC address prefix is used for mapping IP addresses to MAC addresse
-
OSPF stub areas are an important tool for the Network designer; which of the following two shouldbe considered when utilizing OSPF stub areas? ()
A . OSPF stub areas increase the size of the LSDB with the addition of Type 3 and 5 LSAs
B . OSPF not so stubby areas are particularly useful as a simpler form of summarization
C . OSPF stub areas are always insulated from external changes
D . OSPF totally stubby cannot distinguish among ABRs for the best route to destinationsoutsidethe areas
E . OSPF stub areas can distinguish among ASBRs for destinations that are external to the OSPFdomai
-
When designing the IP routing for the Enterprise Campus network, which of these following twoiBGB considerations should be taken into account?()
A . iBGB dual horning with different iSPs puts the Enterprise at the risk of becoming a transitnetwork
B . iBGP requires a full mesh of eBGP peers
C . Routers will not advertise iBGP learned routers to other iBGP peers.
D . The use of route reflections or Confederation eliminate any full mesh requirement while helpingto scale iBGP
E . iGBP peers do not add any information to the AS path
-
Which two are needed components when designing and implementing a security solution?()
A . detailed VLAN information
B . an incident response plan
C . results of testing the new network configuration
D . an existing hierarchical network topology
E . a security policy for your organizatio
-
When considering the design of the IPv6 address plan for the Enterprise Campus network, whichof the following should serve as guidance?()
A . All the IPv6 subnets should use a /32 prefix
B . Set aside /31 prefixes to support point-to-point links and loopback interfaces
C . The IPv6 address plan should be designed to support the service block model design orintegration with IPv4
D . Designate 16 subnet bits to be split up intelligently, either by OSPF area. VLAN numbering, orIPv4 mapping
-
At design time, you create a query record group for the LOV associated with the HOTEL text item in a form module for the Travel Planner Application. When is the record group deleted?()
A . When the user navigates to the HOTEL item.
B . When the form module successfully compiles.
C . After Form Builder validates the SELECT statement and dismisses the New Record Group dialog box.
D . When the user enters data in the HOTEL item, and the Validate from List property for the HOTEL item is set to YES.
-
What are three relevant design considerations when using the 15216 EDFA? ()(Choose three.)
A . dispersion
B . Optical SNR
C . span attenuation
D . four wave mixing
E . receiver sensitivity
-
What kind of elements should be included when we are designing the itinerary?
A、Number of the tourists.
B、Tour destination.
C、Traveling season or time.
D、Traveling budget.
-
8、请判断该句翻译是否正确: If a designer were to design a bracket to support 100 lb. when it should have been figured for 1000 lb., failure would be forthcoming. 如果设计者所设计的托架能支撑100磅,当它被设计为1000磅时,事故一定会出现。
-
Flowcharting is used primarily for program design and rarely for systems design.()
是
否
-
When we design the mechatronic product, what types of design ideas can we apply?
A.developmental design
B.adaptive design
C.variant design
D.normal design
E.electromechanical complementary method
-
听力原文:I work for quite a small advertising agency, and we set up a team for each new project. My job covers both design and responsibility for leading project teams, currently one on a major advertising campaign. I was totally new to project management when I joined the company, but now I find it fascinating. I'm planning to talk to my line manager about altering the balance and doing more of that. Then the job would be ideal.
(17)